Cambium Networks cnMatrix EX2010-P Handleiding (320 Pagina's)

Handleiding

/ 320

Je bekijkt pagina 177 van 320

L3 Features 177

7. Type the exit command into the terminal to go back to the configuration mode. Press the Enter

key.

8. Type the interface vlan 10 command into the terminal to select an interface to be configured and

to go to the configuration interface mode. Press the Enter key.

9. Type the ip address 10.10.10.1 255.255.255.0 command into the terminal to set an IP address for the

configured interface. Press the Enter key.

10. Type the no shutdown command into the terminal to enable an interface. Press the Enter key.

11. Type the exit command into the terminal to go back to the configuration mode. Press the

Enterkey.

12. Type the ip route 20.20.20.0 255.255.255.0 10.10.10.254 command into the terminal to configure a

static route. Press the Enter key.

13. Type the exit command into the terminal to go to the Privileged EXEC mode. Press the Enter key.

14. Type the show ip route command into the terminal to display the IP Routing table and to verify if

thepreviously performed configurationwas successful. Press the Enter key.

For more information, see IP Routing Parameters and Commands.

RIP (Starting with version 2.1)

Managing RIP

Feature Overview

The RIP (Routing Information Protocol) is a dynamic protocol used to find the best route or path from

end-to-end (source to destination) over a network by using a routing metric/hop count algorithm. This

algorithm is used to determine the shortest path from the source to the destination, which allows the

data to be delivered at high speed in the shortest time.

This dynamic protocol represents a distance vector routing protocol, which has the default AD

(Administrative Distance) value of 120, and it works on the application layer of the OSI model.

Note

RIP uses port number 520.

Attention

Dynamic Routing is not supported on EX1028, EX1028-P, EX1010, and EX1010-P

switches, therefore RIP functionality is not available for cnMatrix EX1028,

EX1028-P, EX1010, and EX1010-P.

Scaling Numbers

l

The switch can store a maximum of 512 RIP Routes.

Limitations

/ 320

Bekijk gratis de handleiding van Cambium Networks cnMatrix EX2010-P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.