Café UVC9300SLSS handleiding
Handleiding
Je bekijkt pagina 10 van 60
10 49-2000894 Rev. 5
PRODUCT DIMENSIONS
Installation Preparation
INSTALLATION PREPARATION
CABINET PREPARATION
12"
19-1/4"
18" or 24"
28-1/4" or
34-1/4"
4-1/4"
9"
1-15/16"
3-1/8"
1" 1"
11-1/2"
FRONT VIEW
18-1/2" min.
6-15/16"
11-1/2"
3" 1"
SIDE VIEW
11-1/2"
29" min.
Design varies by model
INSTALLATION CLEARANCES
This vent hood must be installed between the 24"
required minimum and 36" recommended maximum
above the cooking surface.
Ŷ$OZD\VUHIHUWRWKHFRRNWRSRUUDQJHLQVWDOODWLRQ
instructions for product-specific clearances.
NOTE: Installation height should be measured
from the cooking surface to the bottom edge of the
cabinet surface.
NOTE: UL requires any combustible surface to be a
minimum of 30" above the cooking surface. Lower
combustible surfaces may be covered to meet
requirements.
Ŷ7KHFXVWRPFDELQHWLQWHUQDOKHLJKWPXVWEH
18-1/2" minimum for vertical venting and 29"
minimum for recirculation.
Ŷ7KLVKRRGFDQEHYHQWHGWRWKHRXWGRRUVRULW
can be installed for recirculating operation. For
recirculating operation, refer to Recirculating
Installation Planning.
Ŷ7KLVKRRGPD\EHPRXQWHGLQDZDOOFDELQHWRU
installed over an island.
NOTE: The exhaust duct on the hood is closer to
the rear of the hood. It is important to plan for the
alignment to the connection point of the hood.
*24" Minimum required
*36" Maximum recommended
Typically 36"
18-1/2" min.
11-1/2"
6-1/2"
1" = 2.5 cm
2-5/8"
Bekijk gratis de handleiding van Café UVC9300SLSS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Café |
| Model | UVC9300SLSS |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 7434 MB |
