Bunn WEQ-10 System handleiding

20 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 15 van 20
TROUBLESHOOTING
Problem Cause Corrective Action
No water comes out of the
water lter system.
Filter(s) are plugged. Replace lter(s).
Vapor-lock. Rinse system.
Low ow from the water lter
system.
Partially plugged lter(s). Replace lter(s).
Barrel valve partially closed. Rotate lter to fully open position.
Water has carbon nes. All carbon lters have carbon nes
on startup.
Rinse system.
Filter leaks from lter interface. O-Ring is out of position in gland. Inspect O-Ring and set in gland.
Nicked or cut O-Ring(s) on lter. Replace O-Ring or lter.
Missing O-Ring(s) Install O-Ring(s).
Water comes out of the upper
Filter Integrity Port (WQ only).
O-Ring is out of position in gland. Inspect O-Ring and set in gland.
Nicked or cut O-Ring(s) on lter. Replace O-Ring or lter.
Missing O-Ring(s). Install O-Ring(s).
Water comes out of the lower
Filter Integrity Port (WQ only).
Cracked carbon block. Replace lter(s).
Water tastes bad. Cracked carbon block (bypass). Replace lter(s).
Nicked or cut O-Ring(s) on lter. Inspect O-Ring and set in gland.
Pre-lter/scale cartridges are in
parallel.
Change pre/post cartridges to
series.
Biological growth in plumbing. Sanitize plumbing and/or system.
Water leaks from ttings. O-Ring is out of position in gland. Inspect O-Ring and set in gland.
Nicked or cut O-Ring(s) on tting. Replace O-Ring or lter.
Missing O-Ring(s). Install O-Ring(s).
Water leaks from back of mani-
fold/wall.
O-Ring is out of position in gland. Inspect O-Ring and set in gland.
Nicked or cut O-Ring(s) on tting. Replace O-Ring or lter.
Missing O-Ring(s). Install O-Ring(s).
Water leaks from barrel valve. Improper the assembly of barrel
valve sub-assembly.
Replace the barrel valve sub-
assembly.
Pressure gauge indicates 0 psi. Water is turned off. Turn water on.
Pressure gauge has failed. Replace pressure gauge.
Rinse valve is leaking. Open/close lever not closed. Close open/close lever all the way.
Rinse valve failure. Replace rinse valve.
56000.0500 B
7/21 © 2021 Bunn-O-Matic Corporation
Page 15
www.bunn.com
803426

Bekijk gratis de handleiding van Bunn WEQ-10 System, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkBunn
ModelWEQ-10 System
CategorieNiet gecategoriseerd
TaalNederlands
Grootte5997 MB