BSS Audio Prosys PS-8810 handleiding
Handleiding
Je bekijkt pagina 24 van 121
- 24 -
PS-8810
DIGITAL SIGNAL PROCESSOR
Quick Install Procedure
connector to a 100Mbit dedicated switch. The SECONDARY
connector should be wired if a second ‘redundant backup
system’ is to be setup. If using just two units then the
primaries and secondaries can be connected directly
between the units. To conform to the regulatory agencies, the
clamp-on ferrites that are shipped with the unit must be
attached to the CAT-5 cables.
9 Connect any circuits to be used with the Control Port
connector to the unit.
10 Connect the unit to the AC power supply.
11 Set the IQ address on the BSS PS-8810 to an unused IQ
address.
12 If the unit is to be used as a system interface, set the baud rate,
and set the unit to act as system interface (green Interface LED
on) using IQ for Windows software.
13 Set all equipment that will be in the signal chain before or
after the BSS PS-8810.
14 Set and verify all level and gain settings on all amplifiers or
other equipment that will either feed or be connected to the
unit.
Prepare the BSS
PS-8810:
Prepare the audio
system:
Bekijk gratis de handleiding van BSS Audio Prosys PS-8810, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | BSS Audio |
| Model | Prosys PS-8810 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 22586 MB |
