Handleiding
Je bekijkt pagina 4 van 40
4
1. USER INFORMATION
1.1 OPTIONAL WALL CONTROL
This unit can be connected to the VT11W wall control.
• Upon startup, the wall control LED will light up during the boot sequence, and remain ON as the unit
starts to operate after the boot sequence. Press the push button to turn the unit OFF; the wall control
LED will also turn OFF.
• When it is time to perform the filter maintenance, the wall control LED will blink slowly (2 seconds ON,
2 seconds OFF). After the filter maintenance has been performed, press and hold the push button for
5 seconds to reset the filter maintenance reminder.
• Refer to your installer for any other blinking pattern.
1.2 USER SERVICING INSTRUCTIONS
• The metal filter included with this unit should be cleaned every 6 months using water and a mild soap.
To remove the filter(s), open the door, release the filter retaining clip and pull filter(s) out. Allow the
filter to dry completely before putting it back in the unit; when reinserting it in the unit, make sure that
it is standing straight.
• Inspect the outdoor air intake at least once a year.
• During the first year of operation, it is recommended to inspect your unit at a higher frequency,
especially if you live near a highway or in an area where there is a lot of construction work, generating
lots of dust. Your filter(s) may need more frequent cleaning or replacement in these types of
environments.
• Replace the optional MERV filter at least once a year; do not attempt to clean and reuse the optional
MERV filter.
• These recommendations may change according to the environmental conditions in your area.
1.3 COMFORT MODE
Should the air inside your house become too humid, or if such conditions want to be prevented, the
operation mode of your Supply Fan can be changed from a Code-Compliant one (modes 1 to 3) to a
Comfort Mode (modes A to E). Refer to the map in Appendix A to make the right choice.
When making such change, make sure to only change the Mode and to leave the Run time % as it was set
by your installer. If in doubt, refer to your HVAC contractor.
Selected mode Climatic Zones*
1 - Ashrae 2016 Zones 1-4
2 - Ashrae 2010 (factory setting) Zones 1-4
3 - IRC / IMC 2012-2015 Zones 1-4
A - Comfort mode Hot / Humid #1 Zones 2A and 1
B - Comfort mode Hot / Humid #2 Zones 1 and 2A
C - Comfort mode Hot / Dry Zone 2B
D - Comfort mode Mixed / Humid Zones 3A, 4A, 3C and 4C
E - Comfort mode Mixed / Dry Zones 3B and 4B
*As defined by the Department of Energy. Refer to the map in Appendix A.
Bekijk gratis de handleiding van Broan FIN-180P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Broan |
| Model | FIN-180P |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 6425 MB |
