Handleiding
Je bekijkt pagina 43 van 108
• Adjust the hob connections: they are
located underneath the knobs (Fig. 04).
— Proceed one tap at a time.
— Remove the knobs and the gaskets by
pulling them up.
-S
WITCHING FROM NATURAL GAS TO BUTA-
NE/PROPANE
-
With a small flat-head screwdriver, screw
in all the way the brass (yellow) burner
power screws
(Fig. 05),
in a clockwise
direction.
-
Replace the gaskets and the knobs, pay-
ing careful attention to their direction and
ensuring that the knobs are pushed in all
the way.
-S
WITCHING FROM BUTANE/PROPANE TO
NATURAL GAS
- Unscrew the brass (yellow) burner power
screws
(Fig. 05)
, using a small flat-head
screwdriver, by turning two times coun-
terclockwise.
-
Replace the knob,
-
Light the burner in maximum heat mode,
then turn down to reduced heat mode.
-
Remove the knob again, then turn the
burner power screws clockwise until it
reaches the lowest possible setting that
does not extinguish the flame.
-
Replace the gasket and knob.
-
Make several attempts to shift from the
maximum flow rate to the minimum: the
flame should not go out; if it does,
unscrew the burner power screw so as to
obtain good flame retention during these
position switches.
Knob
Gasket
Tap
Fig. 04
EN
INSTALLING YOUR APPLIANCE
39
Burner power
adjustment screw
Fig. 05
Tap axis
Bekijk gratis de handleiding van Brandt BPE6411BM, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Brandt |
| Model | BPE6411BM |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 18326 MB |
Caratteristiche Prodotto
| Apparaatplaatsing | Ingebouwd |
| Soort bediening | Draaiknop |
| Kleur van het product | Zwart |
| Ingebouwd display | Nee |
| Gewicht | 7620 g |
