Botex LED Stripe All-in-One Control handleiding

Niet gecategoriseerd

Botex

40 pagina's

PDF beschikbaar

Handleiding

DANGER!

Risk of death from electrical current!

A short circuit can cause res and loss of life. Always use properly insulated, tripe-core mains cable. Do not modify the mains cable. If

the insulation is damaged, immediately switch o the power supply and have it repaired. If in doubt, contact a qualied electrician.

NOTICE!

Risk of re due to covered vents and neighbouring heat sources!

If the vents of the device are covered or the device is operated in the immediate vicinity of other heat sources, the device can over‐

heat and burst into ames. Never cover the device or the vents. Do not install the device in the immediate vicinity of other heat

sources. Never operate the device in the immediate vicinity of naked ames.

NOTICE!

Damage to the device if operated in unsuitable ambient conditions!

The device can be damaged if it is operated in unsuitable ambient conditions. Only operate the device indoors within the ambient

conditions specied in the “Technical specications” chapter of this user manual. Avoid operating it in environments with direct sun‐

light, heavy dirt and strong vibrations. Avoid operating it in environments with strong temperature uctuations. If temperature uc‐

tuations cannot be avoided (for example after transport in low outside temperatures), do not switch on the device immediately.

Never subject the device to liquids or moisture. Never move the device to another location while it is in operation. In environments

with increased dirt levels (for example due to dust, smoke, nicotine or mist): Have the device cleaned by qualied specialists at reg‐

ular intervals to prevent damage due to overheating and other malfunctions.

NOTICE!

Damage to the device due to high voltages!

The device can be damaged if it is operated with the incorrect voltage or if high voltage peaks occur. In the worst case, excess vol‐

tages can also cause a risk of injury and res. Make sure that the voltage specication on the device matches the local power grid

before plugging in the device. Only operate the device from professionally installed mains sockets that are protected by a residual

current circuit breaker (FI). Ensure that the power cord plug is easily accessible at all times if it is the only device to safely disconnect

the device from the mains supply. As a precaution, disconnect the device from the power grid when storms are approaching or it the

device will not be used for a longer period.

Safety instructions

LED Stripe All-in-One Control

DMX Controller

Bekijk gratis de handleiding van Botex LED Stripe All-in-One Control, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.