Botex LED Stripe All-in-One Control handleiding
Handleiding
Je bekijkt pagina 12 van 40
1. Loosen the screw of the battery holder on the back of the remote control.
2. Push the lock of the battery holder towards the centre of the housing and pull out the
battery holder like a drawer.
3. Insert the batteries. The battery is correct if the positive pole points to the housing base
of the remote control.
4. Slide the battery holder back into the remote until it clicks into place.
5. Tighten the screw of the battery holder.
NOTICE!
Risk of re due to incorrect polarity!
Incorrectly inserted batteries may cause res and destroy the device and the bat‐
teries.
Observe the markings on the batteries and on the device.
Ensure that proper polarity is observed when inserting batteries.
Inserting the battery into the
remote control
Installation
12
LED Stripe All-in-One Control
DMX Controller
Bekijk gratis de handleiding van Botex LED Stripe All-in-One Control, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Botex |
| Model | LED Stripe All-in-One Control |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2162 MB |
