Boss XS-1 handleiding
Handleiding
Je bekijkt pagina 8 van 10
8
Replacing the battery
About the battery
* Batteries should always be installed or replaced before connecting any other devices. This way, you can prevent malfunction and damage.
* If the batteries run extremely low, the sound may distort / interruptions in the sound may occur at high volume levels, but this does not
indicate a malfunction. If this occurs, please replace the batteries / use the AC adaptor (sold separately).
* If operating this unit on batteries, please use alkaline batteries.
* If you handle batteries improperly, you risk explosion and fluid leakage. Make sure that you carefully observe all of the items related to
batteries that are listed in “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (leaflet “USING THE UNIT SAFELY” and Owner’s manual)
* This device already contains a battery when shipped from the factory. This is a test battery, which may not last as long as a new one.
NOTE
¹ When operating on battery power only, the unit’s indicator will become dim when battery power gets too low. Replace the battery as soon as
possible.
¹ If you notice noise when the unit is running on battery power, this may be because the battery is almost depleted. Try replacing the battery or
using a separately sold AC adaptor.
¹ If the CHECK indicator keeps switching on and off when the unit is running on battery power, this may be because the battery is almost
depleted. Try replacing the battery or using a separately sold AC adaptor.
Replacing the battery
Batteries should always be installed or replaced before connecting any other devices. This way, you can prevent malfunction and damage.
Thumbscrew
Spring base
Pedal
Coil spring
Guide bush hole
Battery housing
Battery
Battery snap
Battery snap cord
1 Hold down the pedal and loosen the thumbscrew, then open the pedal upward.
You don’t need to take the thumbscrew out completely to open the pedal.
2 Remove the old battery from the battery housing, and remove the battery snap connected to it.
3 Connect the battery snap to the new battery, and place the battery inside the battery housing.
Be sure to carefully observe the battery’s polarity (+ versus -).
4 Slip the coil spring onto the spring base on the back of the pedal, and then close the pedal.
Carefully avoid getting the snap cord caught in the pedal, coil spring, and battery housing.
5 Finally, hold down the pedal while tightening the thumbscrew into the guide bush hole.
Bekijk gratis de handleiding van Boss XS-1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Boss |
| Model | XS-1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1118 MB |
