Bosch WGG45400TH handleiding

44 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 37 van 44
Troubleshooting en
37
Fault Cause and troubleshooting
E:30 -10 / The filters in the water inflow are blocked.
Clean the filters in the water inflow.
The water pressure is low.
Check whether the tap has sufficient water pres-
sure.
The water level measuring system is defective.
With this error message, the appliance starts a drain-
ing process.
1. Wait approx. 5 minutes until the draining process
ends.
2. Restart the appliance.
If required, start the draining process again.
3. If the fault persists, call customer service.
→Page42
E:30 -20 Critical malfunction.
Turn off the water tap.
With this error message, the appliance starts a drain-
ing process.
1. Wait approx. 5 minutes until the draining process
ends.
2. Restart the appliance.
If required, start the draining process again.
3. If the fault persists, call customer service.
→Page42
Detergent dosage is too high.
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
Additional water has been added.
Do not add any extra water to the appliance while it
is operating.
All other error codes. Malfunction
1. Restart the appliance.
2. If the fault occurs again, disconnect the appliance
from the power supply for at least 30 seconds.
Unplug the appliance from the mains or switch off
the circuit breaker in the fuse box.
3. If the fault persists, call customer service.
→Page42
Please specify the exact error message when call-
ing. If possible, document the fault with photos and
videos.

Bekijk gratis de handleiding van Bosch WGG45400TH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkBosch
ModelWGG45400TH
CategorieWasmachine
TaalNederlands
Grootte3729 MB