Bosch WGB256A2GB handleiding
Handleiding
Je bekijkt pagina 51 van 60
en
51
Fault Cause and troubleshooting
Insufficient cleaning or
detergent residues on
the laundry.
2. Check whether the detergent in the dispenser has
thickened.
3. If the detergent is unsuitable or has thickened,
empty it out and clean the dispenser. →Page40
The basic dosage is not correctly adjusted.
▶
Set the basic dosage. →Page36
Damp stains have
formed on the fabrics
after the Iron Assist
programme has
ended.
Water droplets from the drum or from the door have
moistened the fabrics. The drops come from either
condensed steam or the residual moisture from the
previous wash programme.
▶ Iron the fabrics or hang them up to dry.
The laundry is too wet
after the spinning
cycle.
A low spin speed is selected.
▶ Start the Spin (Prg_Spin (Mandatory for W/
WD))programme.
▶ The next time you run a wash cycle, set a higher
spin speed.
The appliance is using a reduced spin speed to elim-
inate an imbalance.
1. Redistribute the laundry in the drum.
2. Start the Spin (Prg_Spin (Mandatory for W/
WD))programme.
Creasing. The selected programme is unsuitable for the type of
fabric.
▶
Set a suitable programme. →Page27
A high spin speed is selected.
▶ The next time you run a wash cycle, set a lower
spin speed.
The load is unsuitable.
▶ Observe the programme's maximum load capacity.
→Page27
▶
Prepare the laundry. →Page31
Water is leaking out at
the water inlet hose.
The water inlet hose is not correctly connected or is
damaged.
▶ Check the installation of the water inlet hose.
→Page11
In the event of damage, call customer service.
→Page54
Bekijk gratis de handleiding van Bosch WGB256A2GB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bosch |
| Model | WGB256A2GB |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 5085 MB |
