Bosch WAN28283SA handleiding
Handleiding
Je bekijkt pagina 37 van 48
Troubleshooting en
37
Fault Cause and troubleshooting
E:30 -10 / The tap is turned off.
▶ Turn on the tap.
The water inlet hose is kinked or jammed.
▶ Check the installation of the water inlet hose.
→Page12
The filters in the water inflow are blocked.
▶ Clean the filters in the water inflow.
The water pressure is low.
▶ Check whether the tap has sufficient water pres-
sure.
The water level measuring system is defective.
With this error message, the appliance starts a drain-
ing process.
1. Wait approx. 5 minutes until the draining process
ends.
2. Restart the appliance.
If required, start the draining process again.
3. If the fault persists, call customer service.
→Page42
E:30 -20 Critical malfunction.
▶ Turn off the water tap.
With this error message, the appliance starts a drain-
ing process.
1. Wait approx. 5 minutes until the draining process
ends.
2. Restart the appliance.
If required, start the draining process again.
3. If the fault persists, call customer service.
→Page42
Detergent dosage is too high.
▶ Reduce the amount of detergent for the next wash-
ing cycle with the same load.
Additional water has been added.
▶ Do not add any extra water to the appliance while it
is operating.
Bekijk gratis de handleiding van Bosch WAN28283SA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bosch |
| Model | WAN28283SA |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 3886 MB |
