Handleiding
Je bekijkt pagina 22 van 28
22
en Safety systems
Notes:
– Clean all parts immediately after use.
This will prevent residues from drying
on and possibly attacking the plastic
(e.g. essential oils in herbs).
– When processing food such as
carrots, the plastic parts may become
discoloured, but this can be removed
with a few drops of cooking oil.
– To make cleaning the blender jug easier,
remove the cover from the handle and
replace once dry.
In Fig. G, you will find a summary of how to
clean the individual parts. Remove seal for
cleaning.
“ (Cleaning)” programme
For quick and easy cleaning.
■ Attach the empty blender jug on to the
appliance.
■ Fill it with 1.25 litres of warm water and
2 drops of washing-up liquid.
■ Put the lid with the locking cap in place
and press it firmly.
■ Switch the appliance on again and press
the (Cleaning) programme
selection button.
■ The appliance runs through automatic
pre-cleaning and ends the programme
automatically.
■ Switch off the appliance with the
/
(on/off) switch. Disconnect the
mains plug.
■ Remove, the blender jug, the lid with
locking cap and the cushion pad.
■ Rinse all parts thoroughly and clean
again if necessary. (X Fig. G).
■ Clean the base unit.
Safety systems
Start lock-out and
automatic cut-out
The appliance can only be operated if the
blender jug has been correctly positioned
and if the rotary selector is turned to
the zero setting when switching on the
appliance or after an interruption in the
power supply. The appliance will switch off
automatically if the blender jug becomes
detached while it is running. The appliance
automatically switches off in manual
mode (speed (min) – (max))
after 5½ minutes of continuous operation.
X “Troubleshooting” see page 22
Overload protection
The motor switches off automatically if the
appliance overheats. X “Troubleshooting”
see page 22
Note: When activating the overload
protection, a slightly strange smell may
occur. This is not a sign of malfunction.
Troubleshooting
W Risk of injury!
Before dealing with any faults, unplug the
mains plug.
Note: The appliance will no longer
switch on if there is an error in appliance
operation, if the electronic fuses trip or the
appliance has a defect. First try to eliminate
the problem which has occurred with
the help of the following information.
Caution!
If a fault cannot be eliminated, please
contact customer service.
Fault
Appliance fails to start up or switches off
while in use. The status display flashes.
Possible causes
– Blender jug is not correctly positioned,
has become detached or has been
removed.
– Rotary selector was not at the zero
setting when switching on or after an
interruption in power.
– The appliance was operating
continuously in manual mode (speed
(min) – (max)) for longer
than 5½ minutes.
Remedy
■ Switch off the appliance with the
/
(on/off) switch.
■ Position the blender jug correctly.
Bekijk gratis de handleiding van Bosch VitaBoost MMBH6P6BT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bosch |
| Model | VitaBoost MMBH6P6BT |
| Categorie | Blender |
| Taal | Nederlands |
| Grootte | 2660 MB |
