Bosch SHX78DM5N handleiding
Handleiding
Je bekijkt pagina 6 van 12
6 Frequently Asked Questions
Q: Why is food remaining on dishes after I run the cycle?
• It is possible the dishes do not have adequate clearance between them. Also, be sure nothing is blocking the spray arms and
that the filter is clean. Select the Heavy cleaning cycle.
Q: Why does the cycle run a long time?
• Sensors in the dishwasher automatically increase the cycle time to ensure a good wash when heavy soil is detected.
• Incoming water may not be hot enough and dishwasher has to heat it.
Setting Factory setting Description
Rinse Aid
Off/Low/Medium/High
Medium Setting to adjust the amount of rinse aid
used in each cycle.
Intensive drying
Off/On
Off Setting to increase drying ability for glass-
es or plastic. Increases cycle length and
temperature.
End of cycle tone
Off/Low/Medium/High
Medium The volume of the tone signalling the end
of cycle.
5 Settings
5.1 Available Settings
Below are some commonly used settings. To see all the settings refer to the full online manual or go to Dishwasher » Settings in
the Home Connect
®
app.
5.2 Adjusting the settings
First Steps to adjust any setting:
Open the door and press the ON/OFF button.
Hold down Button A for 3 seconds, until the Rinse Aid
indicator light flashes.
Release button, then follow steps below to adjust specific
setting.
To adjust the rinse aid:
1. Press the Start button repeatedly until the right amount
of rinse aid has been set. 0 (off), 1(low), 2(medium),
or 3(high) LEDs above cycle buttons will light up
accordingly.
2. Press button A for 3 seconds to save the setting.
To turn on intensive drying:
1. Press button A until the Clean and Sanitize lights flash.
2. Press the Start button until 1 LED light above the heavy
cycle button is on (intensive dry is on).
3. Press button A for 3 seconds to save the setting.
To adjust the signal volume:
1. Press button A until the Clean and Rinse Aid lights flash.
2. Press the Start button repeatedly until the preferred
volume level has been selected. 0 (off), 1(low), 2(medi-
um), or 3(high) LEDs above cycle buttons will light up
accordingly.
3. Press button A for 3 seconds to save the setting.
To reset to factory settings:
1. Press button A until the Clean, Sanitize and Rinse Aid
lights flash.
2. Press the Start button. The 3 LEDs above cycle buttons
will blink alternatively for 1 minute. The factory settings
have been restored.
Tip: The simplest way to change the settings is with the
Home Connect
®
app.
Bekijk gratis de handleiding van Bosch SHX78DM5N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bosch |
| Model | SHX78DM5N |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 2208 MB |
