Handleiding
Je bekijkt pagina 36 van 88
en-us Troubleshooting
36
Issue Cause and troubleshooting
ERR/toP - Cooktop activation
during active Self Clean function
The cooktop has been activated during an active self clean cycle.
1. Turn off any active cooking zone.
2. Start the self clean function again.
E100 - Zero cross failure on power
board
An electronics fault has occured
1. Turn the appliance off at the circuit breaker and wait five minutes.
2. Turn the circuit breaker back on.
3. If the problem persists, contact Customer Service.
Issue Cause and troubleshooting
Oven door is locked and will not
open, even after cooling
The door lock is engaged
1. Turn the oven off at the circuit breaker and wait five minutes.
2. Turn breaker back on.
a The oven should reset itself and will be operable.
Oven is not heating There is no power supply to the appliance
1. Check circuit breaker or fuse box to your house.
2. Make sure there is proper electrical power to the appliance.
There is no cooking temperature set
▶ Set a heating mode temperature.
Baking results are not as expected The rack position is not ideal
▶ Check "Getting the most out of your appliance" for tips and
suggestions.→
"Getting the best results", Page25
Food takes longer to cook than
expected
The oven temperature needs to be recalibrated
Note:The oven is carefully calibrated to provide accurate results.
▶ If food is consistently too brown or too light the temperature can be offset.
→
"Oven temperature offset", Page23
Food is overcooked The oven temperature needs to be recalibrated
Note:The oven is carefully calibrated to provide accurate results.
▶ If food is consistently too brown or too light the temperature can be offset.
→
"Oven temperature offset", Page23
Oven light is not working properly The oven light bulb is loose or burnt out
▶ Replace or reinsert the light bulb.
→
"Replacing an oven light bulb", Page32
Tip:Touching the bulb with fingers may cause the bulb to burn out.
Oven light does not turn off The oven door does not close properly
1. Check the appliance door for obstructions.
2. Check to see if the hinge is bent.
The oven light is turned on
▶ Press the oven light button to turn the oven light off.
Cannot remove lens cover on light There is soil build-up around the lens cover
1. Let the oven cavity cool off.
2. Wipe the lens cover area with a clean, dry towel, then try to remove the lens
cover.
Oven is not self-cleaning properly The oven is too hot to start self clean
1. Allow the oven to cool before running self clean.
2. Always wipe out loose soils or heavy spillovers before running self clean.
3. If the oven is heavily soiled, set the maximum self clean time.
Bekijk gratis de handleiding van Bosch HGF1050MUC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bosch |
| Model | HGF1050MUC |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 9505 MB |
