Handleiding
Je bekijkt pagina 19 van 92
Water system en-us
19
2. Press the desired selection option and press the
glass against the dispensing button .
‒ Flush the water system if water has not been drawn
for 5days. To flush the water system, dispense
2liters of water.
Tip:Hold the glass directly under the dispenser opening.
Notes
¡ After a while of continuous dispensing, the ice or water
stops being dispensed. Wait a few seconds before
dispensing ice or water again.
¡ After ice or water has been dispensed several times
consecutively, it stops being dispensed. Wait a few
minutes before dispensing ice or water again.
¡ When changing from cubed to crushed, a few ice
cubes may be released the next time you dispense.
¡ When changing from crushed to cubed, a small
amount of crushed ice may be released the next time
you dispense.
Bottle fill option
You can dispense a specific amount of water with the
bottle fill option.
Note:The factory-set amount of water is approx. 500ml.
Filling a bottle
1. Press bottle fill.
2. Place a bottle or jug under the dispenser opening.
3. Press bottle fill.
a The set amount of water is dispensed.
Tips
¡ To stop dispensing early, press any touch field on the
control panel.
¡ To start dispensing again, press bottle fill.
Note:If you do not fill a bottle for some time, the selection
option changes to water.
Setting the amount of water for the bottle fill option
Note:The maximum fill time is 60seconds.
1. Press bottle fill.
2. Place a bottle or jug under the dispenser opening.
3. Select one of the options:
‒ Press and hold bottle fill at the same time until the
desired amount of water is dispensed.
‒ Press / (Freezer compartment) repeatedly until
the temperature display (freezer compartment) shows
the desired water dispensing time in seconds.
a The new amount of water is saved and will be
dispensed for the bottle fill option.
Permanent light
If you do not dispense ice or water for some time, the light
switches itself off.
You can permanently switch on the light on the ice and
water dispenser.
Switching on the permanent light
1. To activate setting mode, touch the lower area of the
control panel.
2. Press light.
a light lights up.
Switching off the permanent light
1. To activate setting mode, touch the lower area of the
control panel.
2. Press light.
a light goes out.
Bekijk gratis de handleiding van Bosch B36CD80SNS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bosch |
| Model | B36CD80SNS |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 11261 MB |
