Handleiding
Je bekijkt pagina 13 van 92
Basic Operation en-us
13
The ethylene absorber slows down the ripening of
ethylene-sensitive fruit and vegetables to keep them
fresher for longer.
Installing the ethylene absorber
▶ Install the ethylene absorber in accordance with the
installation instructions for the ethylene absorber.
Using the refill set
1. Install the components of the refill set in accordance
with the installation instructions for the ethylene
absorber.
2. Replace the bags and timer at least every 6months
following activation.
Note:Refill sets can be purchased from customer service
or our website.
Basic Operation
7 Basic Operation
Basic Operation
7.1 Switching on the appliance
1. Connect the appliance to the electricity supply.
→
Page8
Note:If the appliance has been previously switched off
using the control panel, press and hold 3sec. for
3seconds.
a The control panel shows an animation and is locked.
a The appliance is ready to use once the animation has
ended and the temperature displays light up.
a The motor starts after a delay of up to 5minutes.
a The appliance begins to cool.
a A warning tone sounds and the temperature display
(freezer compartment) and "alarm" flash because the
freezer compartment is still too warm.
2. Switch off the warning tone using alarm.
a "alarm" goes out as soon as the set temperature has
been reached.
3.
Set the desired temperature. →
Page13
7.2 Operating tips
¡ Once you have switched on the appliance, the set
temperature is only reached after several hours.
Do not put any food in the appliance until the set
temperature has been reached.
¡ The front and side panels of thehousing heat up
occasionally. This prevents condensation from forming.
¡ When closing the door, make sure that the door is not
blocked by stored items.
¡ When you close the door, a vacuum may be created.
The door is then difficult to open again. Wait a moment
until the vacuum is offset.
¡ The temperature in the appliance varies due to the
following conditions:
– How often the appliance is opened
– Load capacity
– Temperature of newly stored food
– Ambient temperature
– Direct sunlight
7.3 Switching off the appliance
1. To activate setting mode, touch the upper area of the
control panel.
2. Press and hold 3sec. for 3seconds.
7.4 Setting the temperature unit
You can choose between the temperature unit °F and °C.
1. To activate setting mode, touch the upper area of the
control panel.
2. Press °C/°F.
7.5 Setting the temperature
Setting the refrigerator compartment temperature
1. To activate setting mode, touch the upper area of the
control panel.
2. Press / (Refrigerator compartment) repeatedly
until the temperature display (refrigerator compartment)
shows the desired temperature setting.
The recommended temperature in the refrigerator
compartment is 37°F (3°C).
Setting the freezer compartment temperature
1. To activate setting mode, touch the upper area of the
control panel.
2. Press / (Freezer compartment) repeatedly until
the temperature display (freezer compartment) shows
the desired temperature setting.
The recommended temperature in the freezer
compartment is 0°F (−18°C).
7.6 Keylock
The button lock prevents the appliance from being
operated accidentally or incorrectly while running.
Switching on the keylock
1. To activate setting mode, touch the lower area of the
control panel.
2. Press and hold lock3sec. for 3seconds.
a "lock3sec." lights up.
Switching off the keylock
▶ Press and hold lock3sec. for 3seconds.
a "lock3sec." goes out.
Bekijk gratis de handleiding van Bosch B36CD80SNS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bosch |
| Model | B36CD80SNS |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 11261 MB |
