Handleiding
Je bekijkt pagina 46 van 56
Troubleshooting
EN
46 bora.com
8.3
Cooktop troubleshooting
Operating situation Cause Remedy
The cooktop is displayed but both cooking zone
displays show an error and an error code is
shown in the multi-function display
(e.g. )
Communication error Acknowledge the error or restart the system.
No power supply at the cooktop Have a specialist electrician inspect the cooktop
fuse and power supply respectively
Faulty generator/electronics Contact the BORA Service Team
Cooktop not displayed Cooktop was not recognised Check the communication cable connection
Error code
Overheating Remove hot objects from the immediately vicinity
of the operating panel
Switch off the system and leave it to cool
Clean the air vents on the bottom of the
appliance (only in the case of the Tepan stainless
steel grill)
Contact the BORA Service Team
The cooktops have no output although a power
level has been set and is displayed
The demo mode is active Contact your BORA retailer or the BORA Service
Team
Tab.8.3
Troubleshooting
8.4
Gas cooktop troubleshooting
Operating situation Cause Remedy
When operating for the first time, after a prolonged period without use or after changing the gas bottle:
The burner does not light during initial operation
or after a long period of disuse
There is air in the gas pipe Repeat the ignition process, several times if
necessary (tap the required cooking zone and set
a power level).
Gas cooktop does not react (servomotors do not
calibrate and no ignition)
There is a communication error between the
operating unit and the cooktop (e.g. in the event
of a power cut).
Perform a reset (Gas configuration menu item)
The gas burner cannot be ignited electrically. The fuse or automatic circuit breaker of the
apartment and/or house’s electrical system is
defective or has been triggered.
Change the fuse. Switch the automatic circuit
breaker back on. If necessary, contact a
specialist electrician.
The fuse or the automatic circuit breaker trips
several times.
Contact the BORA Service Team.
The power supply is disconnected. Have a specialist electrician inspect
the power supply.
The gas burners are damp. Dry the gas burner parts (Cleaning and
maintenance).
The gas burner heads and/or the gas burner
cover are not correctly positioned.
Position the gas burner parts correctly.
The electric igniter and/or thermocouple are
dirty
Remove dirt.
Dirt in the gas burner head Clean the parts of the gas burner.
The cooktop does not ignite automatically. Try to ignite it again using the touch surface on
the control knob.
you notice the smell of gas. A leakage point in the gas supply line Switch off the gas supply and immediately
extinguish all open flames. Contact a gas
engineer. Ensure that all connections are tight
(see the installation instructions).
During normal operation:
The gas flame goes out after ignition.
The gas flame goes out during operation.
The gas flame is uneven.
The gas burner parts (burner heads and/or the
gas burner cover) are not correctly positioned.
Position the gas burner parts correctly.
Dirt in the gas outlet openings on the gas burner
head.
Clean the gas burner parts (Cleaning and
maintenance).
Bekijk gratis de handleiding van Bora Classic 2.0 CKCB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bora |
| Model | Classic 2.0 CKCB |
| Categorie | Afzuigkap |
| Taal | Nederlands |
| Grootte | 7782 MB |
