Bompani BO05208E handleiding
Handleiding
Je bekijkt pagina 18 van 91
SM1987
19
After selecting a suitable position, level the machine carefully using
the adjustable feet (Fig. 4).
Particular care must be taken when selecting the position, levelling
the washing machine and ensuring the safety of lock nuts.
If levelling is not carried out correctly, the washing machine will be
unstable and noisy during operation, which may result in damage.
If the machine stands on a carpet fl oor, make sure that air can circulate
freely between the washing machine and the fl oor itself.
It is not recommended that the machine be installed in locations where the temperature is liable to
drop below freezing.
INSTALLING THE MACHINE
SETTING THE MACHINE LEVEL
A
7
6
5
CONNECTION TO THE WATER SUPPLY SYSTEM
The mains water pressure
must be between 0.05 and
1.00 MPa (0.5 - 10 bar.)
Before connecting the water
fi ll hose, open the valve and
allow a quantity of water to
flow. This will censure that
the supply pipes are free from
impurities, such as sand or
rust (this operation is very
important when the washing
machine is being connected
to a new supply system or if
the system has not been used
for a long period of time).
Connect the water fi ll hose
to a 3/4 threaded cold water
outlet.
Place the fi lter washer sup-
plied between the hose and
the valve and hand tighten
the connection as much as
possible (fi g. 5).
■
■
■
■
Fit the washer on the other
end of the supply hose, and
screw it onto the washing
machine (fi g. 6).
N.B.: Use the new pipe sup-
plied with the machine and
do not re-use the old one.
■
If the drain hose is connected
to a fi xed drainage system,
the free end must be inserted
in a pipe of minimum internal
diameter 40 mm.
The drain hose water connec-
tion to the drainage system
must not be hermetically
sealed, as this would cause
air to accumulate and the
water to siphon out.
If the waste water is to be
discharged into a sink or
washbasin, insert the hose in
the special bracket supplied
and hook it over the edge of
the sink or washbasin. Then
tie the hose and bracket to a
tap or similar (fi g. 8). To avoid
overflowing, the sink drain
must be clear of obstructions
and must be able to empty
quickly.
■
■
■
The water supply tap must be
fully open when washing.
The water drain hose must
be placed at least 60 cm and
not more than 90 cm from the
fl oor (fi g. 7).
■
■
8
GB
Bekijk gratis de handleiding van Bompani BO05208E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bompani |
| Model | BO05208E |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 14675 MB |
