Bomann WA 7161 handleiding
Handleiding
Je bekijkt pagina 32 van 64
32
Connect the water inlet hose (cold water connection)
NOTE:
The water pressure must be between 0.03-1.0 MPa.
With higher pressure: use a pressure regulator.
• Check the tight fit of the rubber seals (d) at both
ends of the inlet hose to prevent leakage.
• Connect the water inlet hose to a water thread
with ¾“. Screw the hose firmly in the direction of
the screw thread; pay attention for a tight fit.
• Connect the other end of the inlet hose to the inlet
valve on the appliance back; pay attention for a
tight fit too.
Connect the water drain hose
NOTE:
The drain hose has a length of approx. 1.5 m and,
contrary to the recommendation, could be extended
to a maximum of 4 m with a suitable hose connector.
CAUTION:
To prevent backflow of contaminated water, the free
end of the hose must not come under the water level
of the drain.
• Connect the drain hose to a drainpipe with a min-
imum diameter of 40 mm; alternatively, the drain
hose can be fixed to a sink or directly to the
drainage.
• Always make sure that the hose is not bent or
squeezed. For this purpose, use the delivered
hose retaining bend (a).
• The hose must be installed at a height of min.
850 mm and max. 1250 mm above the floor.
• Secure the hose securely to avoid a change in
position and with it a water leakage.
Electrical connection
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause an electric shock!
• Do not use multiple sockets or extension cords.
• It is not allowed to modify the plug provided with
the appliance! If the plug does not fit properly to
the outlet, let a proper outlet install by an author-
ized specialist.
• The accessibility of the power plug must always
be ensured to disconnect the device from the
power supply in case of an emergency.
• Make sure that the voltage supply matches the
specifications on the rating label (appliance back)
before connecting.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Bekijk gratis de handleiding van Bomann WA 7161, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bomann |
| Model | WA 7161 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 8429 MB |
