Bolin Technology FEX-SN-M02202021 handleiding

Bewakingscamera

Bolin Technology

39 pagina's

PDF beschikbaar

Handleiding

Use IP Video Output

To use IP video output, please refer to PART TWO - NETWORK CAMERA USER MANUAL

Setting Camera over the LAN

To view and configure your camera via the local area network (LAN), you need to install the Controls

(VideoPlugin) for the first time to login the camera IP interface.

1. Connect your camera and your PC as shown in the figure below to ensure the routing is available.

2. Modify the camera settings if necessary, including its IP address and subnet mask.

NOTE

• Default IP address is “192.168.0.13”, default username is “admin”, and default password is “admin”.

Accessing your camera

Before you begin, please check:

1. Make sure the self-test is completed.

2. Your camera is operating properly and connected to the network.

3. The IP camera/encoder only supports IE11, ensure that the PC client you are using is installed with

Internet Explorer 11.

4. Open Internet Explorer on your PC.

5. In the address bar, input the IP address plus the port number of your camera (default IP is

192.168.0.13, so the login URL should be http://192.168.0.13 ), then press Enter to open the login

page.

6. Enter the username (default is “admin”) and password (default is “admin”)

7. Click Login button to access to IP video interface.

To use IP video output, please refer to PART TWO - NETWORK CAMERA USER MANUAL

Bekijk gratis de handleiding van Bolin Technology FEX-SN-M02202021, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.