Bolin Technology EX1030NX handleiding
Handleiding
Je bekijkt pagina 11 van 39
Adjust Output Settings – Use the OSD (On-Screen Display) menu or the web interface to configure the3.
output resolution and frame rate. For detailed instructions, refer to the Web Interface
Configuration
section of this guide.
NOTE: It is recommended to use a high-quality, shielded SDI cable rated for the required
resolution and transmission distance to ensure optimal signal integrity and reliability.
SDI Standard Bandwidth Resolution Supported
SD-SDI 270 Megabits/Second 480i
HD-SDI 1.485 Gigabit/Second 720p / 1080i
3G-SDI 2.970 Gigabit/Second 1080P, 60FPS
IP Stream Out
The camera’s IP stream(s) can be enabled and configured through its web interface. To access the web
interface, the camera must be connected to a Local Area Network (LAN) using a CAT6 cable, either through a
network switch or directly to a computer. Streaming from the camera also requires an active internet (WAN)
connection.
Follow these steps to set up IP streaming:
Connect the Camera to the Network – Plug one end of a CAT6 cable into the camera’s LAN/PoE++ port1.
and connect the other end to either a network switch or directly to a computer.
Access the Web Interface – On a computer, open an HTML5-enabled web browser and enter the2.
camera’s IP address. By default, the camera is set to DHCP, so the IP address is assigned by the
network.
Enable and Configure Streaming – In the web interface, navigate to the "AV Setup" menu on the left side.3.
From here, enable and adjust the IP stream settings as needed.
VISCA over IP
Bolin PTZ cameras support VISCA over IP communication, allowing for remote control and integration with
compatible systems over a network. To establish a connection, ensure that your control system or software is
configured to communicate with the camera using port 52381.
Key Requirements:
Network Configuration: The camera and control device must be on the same subnet or properly routed for
network communication.
Port Settings: Ensure that port 52381 is open and accessible for VISCA over IP commands.
Control Protocol: Standard VISCA over IP commands can be used for functions such as pan, tilt, zoom,
focus, and preset recalls.
NOTE: The VISCA over IP port of the controller MUST be set to 52381 to communicate with
and control the camera.
ONVIF Protocol
Bolin PTZ cameras support ONVIF 2.4 (Profile S), ensuring compatibility with a wide range of third-party
applications, including PTZ controllers and streaming software. These cameras use the standard ONVIF port
2000 for communication.
ONVIF compliance enables device discovery, video streaming, and PTZ control, making these cameras ideal
for live production, broadcasting, and professional AV workflows.
Integrating with ONVIF-Supported Software:
Ensure the camera is connected to the network and properly configured.1.
Bekijk gratis de handleiding van Bolin Technology EX1030NX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bolin Technology |
| Model | EX1030NX |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 9560 MB |
