Bolin Technology EX1030H handleiding
Handleiding
Je bekijkt pagina 28 van 39
Reload Preset 1: Enable this option to automatically switch to the default preset when powering on the
camera.
System
The System page is to configure the various communications parameters of the camera.
Pelco ID: When utilizing RS485 (PELCO P/D) control, assign the Camera ID to the specific address you
wish to control. The value for this setting can range from 1 to 255.
VISCA ID: When utilizing RS422 (VISCA) control, assign the Camera ID to the specific address you wish to
control. The value for the setting can range from 1 to 7.
Comm Type: Describes communication type.
Baud Rate: The rate of data transfer, measured in bits per second.
Display Info: When this setting is enabled, a message displaying the camera’s configuration will appear on
the screen for approximately 10 seconds each time the camera is powered on or restarted.
Factory Reset: Resetting all the above settings to factory default.
Video Setup
Streaming Server
From the Streaming Server tab, users can set up an IP stream to be sent from the camera to any destination
via the network connection. This camera is capable of sending up to IP stream via RTSP, RTMP, SRT, MPEG-
TS UDP, and MPEG-TS RTP.
Bekijk gratis de handleiding van Bolin Technology EX1030H, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bolin Technology |
| Model | EX1030H |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 9433 MB |
