Bluetti D40 handleiding
Handleiding
Je bekijkt pagina 14 van 24
Notice:
• Make sure that the solar panels have an open-circuit voltage of 13V-36V. The D40 automatically
turns on when the input voltage reaches 13V or higher and turns off when the voltage falls
below 11.7V.
• When connected to solar panels, the D40 supports a maximum input current of 20A and
a maximum output current of 30A.
• When both solar panels and the power station are connected, the D40 prioritizes solar
input when the solar input power reaches or exceeds around 40W, smoothly switching to
the power station below around 40W.
Preparation
• Check that the solar panels and D40 are in good condition, and that the PV input
voltage is in the 12V-36V range. The PV input activates automatically when the voltage
reaches 13V.
• Make sure that the house battery is compatible with the D40.
• Assemble the necessary connection cables and connectors correctly.
Wiring & Operations
1. Connect the solar panel to the D40 via the Anderson connector (red), ensuring correct
polarity.
Make sure that the PV input voltage falls within 12V to 36V. The D40 automatically
activates once the voltage reaches 13V.
2. Press ( ) to navigate until the PV/ENGINE indicator in CHARGE STATUS section flashes.
3. Press and hold ( ) for more than 3 seconds until the indicator turns off. Then, press
and hold ( ) for another 3 seconds until the indicator becomes steady, indicating the
power supply has switched to the PV.
4. Press ( ) again to navigate the flashing indicator back to the CHARGE PROFILE section.
5. Select the battery type for charging:
a. Press and hold ( ) for more than 3 seconds, and when the CHARGE PROFILE
indicator flashes, you can select the battery type.
b. Press ( ) to navigate and select the battery type; the corresponding indicator will flash.
c. Press and hold ( ) for more than 3 seconds until the flashing indicator becomes steady.
6. Connect the D40's DC output to the battery using the Anderson connector, and make
sure to match the positive and negative terminals. The Charging indicator will remain lit
if the charging is successful.
EN
JUST POWER ON
14
Bekijk gratis de handleiding van Bluetti D40, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bluetti |
| Model | D40 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1883 MB |
