Handleiding
Je bekijkt pagina 22 van 60
EN / 22
Anti-tip stability device
The product should be secured against los-
ing its balance and falling by using the anti-
tip stability device supplied with your
product.
1. Draw a straight vertical line from the
center of the back wall of the area
where you will place the product.
2. Using the center as a reference, fix the
anti-tip stability device to the wall in ex-
act dimensions according to the dimen-
sions given below.
An anti-tip stability device is sup-
plied with the product. You can use
this piece on the right or left. The
relevant dimensions for both sides
are given above. The installation is
shown on the left as an example.
3. Place the anti-tip stability device you
fixed to the wall into the slot on the back
of the product as shown below.
4.2 Electrical connection
General warnings
• Disconnect the product from the electric
connection before starting any work on
the electrical installation. There is an
electric shock hazard.
• Connect the product to a grounded out-
let/line protected by a miniature circuit
breaker of suitable capacity as stated in
the "Technical specifications" table. Have
the grounding installation made by a
qualified electrician while using the
product with or without a transformer.
Our company shall not be liable for any
damages that will arise due to using the
product without a grounding installation
in accordance with the local regulations.
• The product can only be connected to the
mains electricity connection by an au-
thorized and qualified person, and the
warranty of the product starts only after
correct installation. The manufacturer
cannot be held responsible for any dam-
ages that may arise due to operations by
unauthorized persons.
• The electric cable must not be crushed,
folded, jammed or touch hot parts of the
product. If the electric cable is damaged,
it must be replaced by a qualified electri-
cian. Otherwise there is an electric shock,
short circuit or fire hazard!
• The mains supply data must correspond
to the data specified on the type label of
the product. The rating plate is either
seen when the door or the lower cover of
the appliance is opened or it is located at
the rear wall of the appliance depending
on the appliance type.
• Power cable plug must be within easy
reach after installation (do not route it
above the hob). Do not use extension or
multi sockets in power connection.
• and must use the appropriate socket out-
let/line and plug for oven. In case of the
product's power limits are out of current
carrying capability of plug and socket
outlet/line, the product must be connec-
ted through fixed electrical installation
directly without using plug and socket
outlet/line.
• If the product will be connected directly
to the supply power: If it is not possible
to disconnect all poles in the supply
power, a disconnection unit with at least
3 mm contact clearance (fuses, line
Bekijk gratis de handleiding van Blomberg HIRN651N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Blomberg |
| Model | HIRN651N |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 6491 MB |
