Handleiding
Je bekijkt pagina 9 van 39
7
Installation
Electrical Connection and Ventilation
ELECTRICAL CONNECTION
NOTE: Electrical connections must be performed by a
qualied installer only.
Before making any electrical connections to these appli-
ances, check that the power supply is adequate for the
voltage, amperage, and phase requirements stated on
the rating name plate mounted on the appliance.
1. The rating plate is located on the right side of the
oven.
An approved plug outlet or a safety cutout must be locat-
ed close to the oven so that the oven can be disconnected
during installation and repair. The safety cutout must be
able to cut o all poles with a total distance of break of at
least 3 mm.
All appliances must be installed in accordance with Local
or National Electrical codes.
This appliance uses a variable frequency drive, which can
be known to product high frequency electrical noise. In
some cases units must be hard wired. This avoids false
positives on ground fault devices susceptible to errors
from electrical noise. All installations must comply with lo-
cal and national codes.
The wiring diagram is located in the motor compartment.
NOTE: Disconnect the power supply to the appliance
before servicing.
WARNING!!
Improper installation may invalidate your war-
ranty.
A strain relief for the power supply cord is provided. The
installer must supply a cord that meets all Local and Na-
tional installation standards.
WARNING!!
If the supply cord is damaged, it must be re-
placed by a special cord or assembly available
from the manufacturer or its service agent.
Bekijk gratis de handleiding van Blodgett Hoodini BLCT-10E-H, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Blodgett |
| Model | Hoodini BLCT-10E-H |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 5603 MB |
