Blizzard wiCICLE Ion handleiding
Handleiding
Je bekijkt pagina 2 van 2
DESCRIPTION OF STATUS INDICATOR
Protocol Action Status Description
6/7 CH
Skywire
Flashing Red Connection is not Established
Flashing Green Receiving DMX Signal
W-DMX
Receive
Protocol
White Connection is not Established
Red Deleting Connection
Red (Fast Flash) Connection is Lost
Green (Fast Flash) Connecting to Transmitter
Green (Slow Flash) Connected, Without DMX Signal
Green Connected, Receiving DMX Signal
BEFORE DOING ANYTHING ELSE, YOU SHOULD DISABLE ANY BUILT-IN
PROGRAMS IN THE FIXTURES YOU WISH TO CONNECT AND/OR SET THEM AS
SLAVES PRIOR TO RETURNING THEM TO DMX MODE (IF APPLICABLE). Many
xtures contain a built-in automatic, sound active or custom programs which
are designed to operate with the xture NOT connected to a DMX chain.
Ready to move on? Well alrighty!
1. Plug your transmitting unit into the “DMX OUT” connector of the controller and
verify it is receiving power (if you are using a controller with a built-in wireless DMX
transmitter, enable it.) Please refer to the manual of the transmitting device for
specic instructions on enabling wireless DMX output.
Setup Mode
1. Press and hold the Function Button before, and during switching on your wiCICLE
Ion™ receiver. When you the see the wireless status LED turn to white light, release
the button to enter Setup Mode.
2. In Setup Mode, you can select from the available wireless protocols. Each time
you press the button, you will see the status indicator change color. When your choice
of is illuminated, press and hold the button (> 1S). When you see the white light,
release it to enter its Use Mode of receiving.
• 6CH Skywire™ Protocol: RED
• W-DMX Receive Protocol: GREEN
• 7CH Skywire™ (wiCICLE™ compatible) Protocol: YELLOW
*Note: The top level BLUE channel mode currently has no function.
Use Mode
In 6CH Skywire™ protocol or 7CH Skywire™ protocol, you can make your selection
of the dierent DMX group colors.
1. The rst time you press the function button it will not change the group color,
but show you the group that you are currently in.
2. Press it again, and you will cycle through the available color groups.
W-DMX Receive Protocol
1. If your W-DMX™ signal transmitter is sending a signal, it should automatically
sync with the wiCICLE® Ion™. If you press and hold the button on the wiCICLE
Ion™ (> 3S), the indicator will turn white, and disconnect from the transmitter.
*Note: A receiver can only be connected to a “new” transmitter after any existing
connection is disconnected.
wiCICLE® Ion™ Pin-Up Picture:
SPECIFICATIONS
Voltage: DC 5V, ±5%
Supplied by 100~240V, 50/60Hz
AC Adaptor or directly by
wiCICLE
®
ENABLED Fixtures
Power Input: 1A MK5P Micro USB Female Plug
Battery: 3.7V / 300mAh (47 x 14 x 6mm)
Charge Time: Less than 1 hour
Working/Standby Time: 6+ hours
Operating Band: 2.402 - 2.480GHz, ISM
Max Operating Range: 1000 FT (Line of Sight)
Receiver Sensitivity: -94dB
Data Output: 3-Pin Locking XLR Female
Protocol: USITT DMX-512
Dimensions: 3.98”(L) x 0.77” (Diameter) 101.2 x 19.5 mm
Weight: .24 Lbs. / .11 kgs.
Warranty: 2 Years
OPERATION, TIPS & TRICKS
• You will need a separate wireless DMX transmitter with either Blizzard
Skywire™ or Wireless Solution® W-DMX™ capabilities.
Charging the Battery
• The internal battery must be charged by using the included AC power adapter.
While this unit may receive direct power and run o of a wiCICLE® Enabled
xture’s XLR plug, this will not charge the battery.
• Charging Indicator: While charging, the indicator will be red. When a full charge
is complete, the light will turn green (normally less than 1 hour.)
• Power Indicator: When battery power runs low, the power indicator light will
turn red. This unit can be charged in either the ON/OFF state.
POSSIBLE CONFIGURATIONS
The diagrams below show possible congurations. Multiple receivers may be used in
any possible conguration.
Tx
Rx
Rx
Tx
Rx
Rx
Tx Rx
CONNECTION TABLE
This table shows the status LED colors from the top menu to the channel selection.
Top Menu
LED
Color
Mode
Channel
LED Color
Red
Skywire™ 6CH
(AnyFi™ compatible)
To make this
transition from
the Top Menu to
Channel Menu,
press the Function
Key.
Red CH1
Green CH2
Blue CH3
Yellow CH4
Cyan CH5
Purple CH6
Green W-DMX Receive (G3 or G4)
Blue No Function
Yellow
Skywire™ 7CH
(wiCICLE™ compatible)
Red CH1
Green CH2
Yellow CH3
Blue CH4
Purple CH5
Cyan CH6
White CH7
3
2
1
5
6
4
1. Function Button
2. Wireless Status Indicator
3. Power Switch
4. Charging Connector
5. Power Indicator
6. Charging Indicator
Bekijk gratis de handleiding van Blizzard wiCICLE Ion, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Blizzard |
| Model | wiCICLE Ion |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 561 MB |
