Blizzard Lux Reactor handleiding
Handleiding
Je bekijkt pagina 9 van 16
Page 9
Lux Reactor™ Manual - Rev. A © 2025 Blizzard Lighting, LLC
Fixture Linking (Master/Slave Mode)
1. Connect the (male) 5-pin connector side of the DMX cable to the output (female)
5-pin connector of the rst xture.
2. Connect the end of the cable coming from the rst xture which will have a (female)
5-pin connector to the input connector of the next xture consisting of a (male) 5-pin
connector. Then, proceed to connect from the output as stated above to the input of
the following xture and so on.
Mounting & Rigging
The xture bracket features three 12mm holes for secure mounting with standard truss
clamps (not included).
Use only suitable “C” or “O” type clamps, each rated to support at least 10x the xture’s
weight. Do not mount to surfaces of unknown strength. Always use properly rated rigging
when installing overhead.
This xture may be mounted in any safe position, provided there is adequate ventilation.
Never block the fan or vent openings.
To adjust the xture angle, loosen both knobs, tilt to the desired position, then retighten
securely.
Always allow enough access for routine maintenance.
A safety cable MUST always be used.
Do not install the xture where it will be exposed to rain, high humidity, extreme tempera-
tures, or restricted airow.
Fixture bracket with clamp mounting points.
Clamps
Bekijk gratis de handleiding van Blizzard Lux Reactor, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Blizzard |
| Model | Lux Reactor |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1820 MB |
