Blizzard AtmosFEAR Tour HZ handleiding
Handleiding
Je bekijkt pagina 7 van 12
Page 7
AtmosFEAR® Tour HZ Manual - Rev. D (c) 2020 Blizzard Lighting, LLC
Cable Connectors
Cables must have a male XLR connector on one end and a female XLR
connector on the other end. (Duh!)
CAUTION: Do not allow contact between the common and the
xture’s chassis ground. Grounding the common can cause a ground
loop, and your xture may perform erratically. Test cables with an
ohm meter to verify correct polarity and to make sure the pins are not
grounded or shorted to the shield or each other.
Take It To The Next Level: Setting Up DMX Control
Step 1: Connect the male connector of the DMX cable to the female
connector (output) on the controller.
Step 2: Connect the female
connector of the DMX cable to the
rst unit’s male connector (input).
Note: It doesn’t matter which unit
address is the rst one connected.
We recommend connecting them
in terms of their proximity to the
controller, rather than connecting
the lowest xture number rst, and
so on.
Step 3: Connect others in the chain
from output to input as above.
Place a DMX terminator on the
output of the nal unit to ensure
best communication.
Bekijk gratis de handleiding van Blizzard AtmosFEAR Tour HZ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Blizzard |
| Model | AtmosFEAR Tour HZ |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 1659 MB |
