Handleiding
Je bekijkt pagina 18 van 156
16
4.2 STEALTH 875™ & STEALTH 885™
4.2.1 Installation
Stealth Above Counter Installation
• Select a location that is near an electrical outlet� Also consider proximity to
ingredients, and patrons as well as available counter space�
• Place the blender on the counter in a spot where the air intake vents on the
sides and exhaust on the back of the blender are unobstructed�
• Ensure there is enough room above and around the unit to allow for unhampered
movement of the sound enclosure (see Figure 1 for measurements)�
• Plug the unit into an outlet with appropriate electrical protection�
Stealth In-Counter - Preparation for Installation
Note: You may locate your Blendtec Stealth in the same space as your previous
Blendtec in-counter blender. Just remember to ensure proper spacing for the
sound enclosure (see Figure 1 for measurements).
• Identify the desired blender location� Consider proximity to ingredients, and
patrons as well as available counter space� Also ensure that an electrical outlet
is readily accessible�
• Ensure the location meets all dimensional requirements (see Figures 1 and 3)�
• The countertop can be no thicker than ¾” (1�9 cm)� A thicker countertop will obstruct
motor ventilation�
• If installing more than one blender, allow 14”–16” (35�6 - 40�6 cm) of center-to-center
blender spacing�
• If installing a sound enclosure, allow a clearance of at least 5 ½” (14 cm) from the
sound enclosure to the wall and 26” (66 cm) from the countertop to any over-the-
counter cabinetry�
• Ensure lower cabinetry allows adequate airflow�
• The blender draws ambient air into the vent holes located on the lower back of
the motor and then evacuates hot air through the vents located on the lower front
and sides of the motor� For the motor to cool properly, a sufficient amount of air
must be able to circulate around the motor�
• There should be at least 6 ½” (16�5 cm) of space from the countertop to the
next lower shelf of the cabinet, leaving a minimum space of 3” (7�6 cm) between
the bottom of the motor and the lower shelf� Cabinetry should not be closed; it
should allow air to flow freely from the outside to the inside of the cabinet space�
• Plastic bags, cups, and so forth, should not be stored closer than 3” (7�6 cm) from
the bottom of the motor�
• Cut a hole in the countertop 4 ⅜“ (11�1 cm) wide and 5 ⅞” (14�9 cm) long (see the
countertop hole template in Appendix A)� Ensure that the 4 ⅜” (11�1 cm) sides are
parallel with the machine operator�
Note: Double check to ensure that all space requirements and measurements
are correct BEFORE cutting.
Bekijk gratis de handleiding van Blendtec STEALTH 895 NBS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Blendtec |
| Model | STEALTH 895 NBS |
| Categorie | Blender |
| Taal | Nederlands |
| Grootte | 14999 MB |
