Blaupunkt TPMS 3.0 handleiding
Handleiding
Je bekijkt pagina 8 van 16
1.
2.
7
DISPLAY INSTALLATION
Sticking area
Sticking area
TROUBLESHOOTING
If any of the following problems occur, please refer to the Troubleshooting section for potential solutions. If the
problem persists, seek assistance from an authorized Blaupunkt dealer.
Problems
Air leakage after sensor installation
No tire data are displayed after
completing installation
Missing or lost sensor
External sensor battery low
Change of tire location
Solutions
The tire valves may not be universal standard, please check with the
local dealer
Ensure ACC is turned on
If external sensor, check rubber seal condition
New installation requires user to drive above 2 km/h for about 5min
Please purchase new sensor
Please replace with battery CR1632
Please reprogram the corresponding sensors
Refer to Tire Position Exchange Setting (P2)
Remove the protective lm from the
3M tape and place it on the bracket.
Remove the protective lm from the other
side of the 3M tape as well.
3.
4.
Place the bracket and ax it to the center
of the back of the display.
Attach the display with the bracket to the
blades of car’s air conditioning vent, then
adjust it to the desired position and angle.
Bekijk gratis de handleiding van Blaupunkt TPMS 3.0, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Blaupunkt |
| Model | TPMS 3.0 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1040 MB |
