Handleiding
Je bekijkt pagina 20 van 64
20
What to do if... Possible reasons Solutions
The control panel
is switched off, the
appliance does not
work.
There may be an appliance
power supply problem.
Check that:
• there is not a power outage;
• the plug is properly inserted in the socket and any
bipolar power switch is in the correct position (this
enables the power supply to the appliance);
• the household electrical system protection devices
are efficient;
• the power cable is not damaged.
The appliance could be in On/
stand by mode.
Turn the appliance on by briey pressing the button (see On/Stand-
by function).
The inside light does
not work.
The light may need to be
replace.Malfunction of a
technical component.
Disconnect the appliance from the power supply and
contact the Technical Assistance Service if you need a
replacement.
The inside light
flashes.
Door alarm active.
It is activated when the
refrigerator compartment door
remains open for a prolonged
period of time.
To stop the alarm, close the refrigerator door.
On reopening the door, check the light works.
The temperature
inside the
compartments is not
low enough.
There could be various causes
(see “Solutions”).
Check that:
• the door closes properly;
• the appliance is not installed near a heat source;
• the set temperature is adequate;
• the circulation of air through the vents at the bottom
of the appliance is not obstructed (see installation
section).
There is water on
the bottom of
the refrigerator
compartment.
The defrost water drain is
blocked.
Clean the defrosting water drain (see section
“Cleaning and Maintenance").
Excessive amount of
frost in the freezer
compartment.
The door to the freezer
compartment is not closed
properly.
• Check that there is nothing preventing the door
from closing properly.
• Defrost the freezer compartment.
• Make sure the appliance has been correctly installed.
The front edge of
the appliance that
the door gaskets seal
against is hot.
This is not a defect. It prevents
condensation from forming.
No solution is necessary.
One or more green
symbols are flashing
continuously and
it is not possible
to change the
temperature set.
Malfunction alarm.
The alarm indicates a fault in a
technical component.
Contact Technical Assistance Service.
The temperature
of the refrigerator
compartment is too
cold.
• The set temperature is too
cold.
• A large amount of fresh food
may have been placed in the
freezer compartment.
• Try to set a less cold temperature.
• If fresh food has been placed in the freezer
compartment, wait until it has fully frozen.
• Turn off the fan (if present) following the procedure
described in the paragraph “FAN”.
TROUBLESHOOTING
Bekijk gratis de handleiding van Blaupunkt 5CN224FD0, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Blaupunkt |
| Model | 5CN224FD0 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 8071 MB |
