Blackstar Polar 4 handleiding
Handleiding
Je bekijkt pagina 10 van 28
10
Panels – A Closer Look (cont’d)
Headphone Level Controls and Outputs
Polar’s headphone outputs are designed
to drive both low and high impedance
headphones, providing clear and accurate
monitoring.
The Headphone Output Jacks are ¼”
stereo jacks.
The dedicated Headphone Level Controls
allows you to adjust the headphone level independently from your monitors.
If your headphones only have a 3.5mm connector, you can use a stereo 3.5mm
to stereo 6.35mm (1/4”) adapter to connect to Polar’s headphone output.
Using headphones with a TS or TRRS connector (such as headphones with a
microphone or volume control built into the cable) will most likely not work. We
always recommend using headphones with a stereo connector and/or stereo
adapter.
Balanced Outputs
Outputs 1/L, 2/R, 3 and 4 are line-
level outputs designed to connect your
POLAR 4 to active monitors or devices
that take a line level input. These outputs
use balanced 1/4” TRS jacks and can
accommodate both unbalanced TS and balanced TRS jack cables.
The Monitor Level Control on the top panel of your POLAR 4 adjusts the
output level for Outputs 1/L and 2/R.
MIDI
For more information on MIDI see page 24
DC 5V Power Input
Most computers will have no issues supplying power to your
POLAR 4 over USB, however, if you are using additional
peripherals or high-power devices alongside your POLAR 4, the
computer’s USB port may not supply enough power.
You’ll usually know when this happens if the POLAR 4 keeps
disconnecting during intense usage, for example, playing
headphones at a loud level and powering two condenser
microphones with phantom power.
For these cases, the DC 5V Power Input allows you to power your Polar Audio
Interface using DC 5V power. Use the included USB to 5V cable to connect your
adapter to any standard DC 5V power adapter.
USB-C
The USB-C connection on the Polar Audio Interface is used to
connect the interface to your computer. This connection facilitates
power supply, data transfer, and communication to the Polar
Control software.
Use the included USB-A to USB-C cable to connect directly to an
open USB-C port on your computer.
IMPORTANT: Avoid connecting your POLAR 4 to your computer using a USB hub, as this
will cause issues and is not supported.
NOTE: When using iOS devices, you must power your POLAR 4 with DC 5V. For more
details, see the iOS section on page 22.
OFF
ON
+48V
HEADPHONES
1/L
2/R
OUTPUTS
USB-C
DC 5V 1A
1/L
2/R
OUTPUTS
USB-C
DC 5V 1A
Contents Page
Bekijk gratis de handleiding van Blackstar Polar 4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Blackstar |
| Model | Polar 4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6227 MB |
