Bissell CrossWave HydroSteam 3517F handleiding

Stoomreiniger

Bissell

12 pagina's

PDF beschikbaar

Handleiding

10 global.BISSELL.com

Problem Possible Cause Remedies

Streaking

or loss of

suction

power

Too much solution dispensed. Go over area without spraying solution.

Brush roll window is not latched. Reinstall brush roll window.

Debris channel in foot is clogged. Clean the channel with a paper towel.

Filter is clogged by debris and/or is wet. Remove debris clogging filter screen. Clean and dry the filter.

Brush roll is wet and dirty. Clean and dry the brush roll.

Dirty tank is full. Empty tank. Follow steps on page 8.

No spray or

steam

Clean water tank is empty. Refill tank. Follow steps on page 5.

Clean water tank is not seated properly. Remove and reseat tank.

Not holding trigger to spray solution. Hold spray solution trigger continuously while using the

machine.

SteamWash™ is turned off. Press the mode button on the handle to change to SteamWash

mode. Ensure the steam indicator light is on.

Steam system is not primed. Prime the machine by holding the trigger for 30 seconds,

expelling steam.

Steam ports are clogged. Wipe the underside of the front steam bar with a wet towel.

Leaking

Clean water tank or lid is damaged. Remove tank from machine and inspect for damage on tank

and/or lid. If damage is found, contact us.

Dirty water tank is damaged. Remove tank from the machine and inspect for damage.

If damage is found, contact us.

Dirty water tank is full. Empty tank. Follow steps on page 8.

Brush

roll isn’t

turning

Brush roll is not installed properly. Follow instructions on page 4 for reinstalling brush roll.

Machine is standing upright. Recline machine to turn brush roll on.

Brush roll stalled by debris. Unplug machine and remove brush window and brush roll to

remove obstruction.

Clean-Out

Cycle not

working

Machine is not on storage tray / tray is

not plugged in.

Place machine on storage tray and plug in.

Clean tank low. Refill tank.

Machine

won’t turn

Brush roll stalled by debris. Unplug machine. Remove brush window and brush roll to

remove obstruction.

Handle not installed properly. Reinstall handle and push down until it clicks into place.

Drips on

the floor

during

cleaning

Cleaning with water only. Add BISSELL cleaning formula to tank.

Holding the trigger after cleaning pass. Release the trigger to stop dispensing solution and steam,

making forward and backward passes to suction excess water.

Note: Any other servicing should be performed by an authorised service representative.

Troubleshooting

Below are some of the issues you may run into. If you don’t see the issue you’re

experiencing below, visit global.BISSELL.com.

WARNING To reduce the risk of ﬁre, electric shock or injury, turn power OFF and disconnect plug from

electrical outlet before performing maintenance or troubleshooting.

Bekijk gratis de handleiding van Bissell CrossWave HydroSteam 3517F, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.