Beverage-Air GF48HC-B handleiding
Handleiding
Je bekijkt pagina 7 van 22
User Manual for GF Glass Freezers Beverage-Air
Rev. 04/25 Beverage-Air 7
UNPACKING AND SET UP
Carefully inspect the shipping carton for damage. This is the only time that shipping damage may be claimed. If damage is
suspected, open the carton immediately and, if there is damage, retain the carton and contact the shipper to make a claim.
Do NOT contact the manufacturer.
Uncrating
Tools Needed: ¾” box wrench, adjustable wrench, level,
at head screw driver, and box cutter.
1. First, remove the cardboard top capping, all clear
tape, and all staples including those at the bottom of
the cardboard carton and skid.
2. Next, start from the top of the carton. Using the box
cutter, carefully make one continuous cut to the
bottom of the skid. Remove cardboard carton and
discard.
3. Then, move unit as close to nal position as possible
before removing the skid.
4. Remove the brackets securing the unit to the skid.
Note: The skid must be removed before the legs can be
attached.
Do NOT tip unit on its front or sides. If tipped onto the
back, unit must not be started for 3 hours.
Skid Removal and Leg Attachment
Tip the unit forward and remove the skid.
Risk of personal injury.
Unit must be securely supported
while attaching legs.
WARNING
1. Remove the shipping bolts using the ¾” box wrench
while cabinet is held in one direction. Repeat the process
while the cabinet is held in the opposite direction.
2. None of the threads on the leg should be visible once
screwed in.
3. Tilt the cabinet in one direction approximately 8” and
block it securely with pieces of 2x4 lumber or other
suitable material.
4. Thread the legs into the ½ -13 holes in the bottom of
the cabinet. Tighten by hand as much as possible.
Some models may already have levelers installed. If
so, then the levelers will need to rst be removed and
discarded.
5. Once the leg cannot be turned any further, use a 3/4
inch wrench to tighten the nut until snug.
6. Repeat this procedure with unit secured in the
opposite direction so as to access the remaining legs/
levelers
Leveling:
Cabinets must be leveled when installed. Level should be
measured on the headrail.
Failure to level your cabinet may result in door not
sealing, closing correctly, or condensed water draining not
draining properly.
For cabinets with legs, rotate the foot of the leg with an
adjustable wrench to achieve desired height for leveling.
Do NOT loosen legs to level the cabinet.
Legs MUST be tightly secured to cabinet for full strength.
Install or attach any accessories
that will be used
Remove any plastic covering the
stainless steel.
CAUTION
Bekijk gratis de handleiding van Beverage-Air GF48HC-B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Beverage-Air |
| Model | GF48HC-B |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 2664 MB |
