Bertazzoni PRO95I2EROT handleiding
Handleiding
Je bekijkt pagina 4 van 31
4
APPLIANCE MAINTENANCE
ATTENTION: IMPORTANT WARNINGS
For cookers resting on a base
ATTENTION: If the cooker rests on a base, take the measures necessary to prev
ent the cooker from
sliding along the support base.
For cookers with electric ovens
The unit becomes hot during use. Do not touch the heating elements inside the oven.
For cookers with electric ovens
ATTENTION: The accessible parts can become hot during use. Keep children away from the appliance.
For the food warmer compartment (or drop leaf in our case)
ATTENTION: The internal parts of the food warmer can become hot during use.
For glass doors
Do not use abrasive cleaning products or metal spatulas with sharp edges to clean the oven door’s
glass since this could scratch the surface and the glass could break.
Do not use steam cleaners to clean the appliance.
The appliance is not intended to be operated by means of external timer or separated remote-control
system (IEC 60336-2-6)
Danger of fire: Do not store items on the cooking surfaces.
CAUTION: The cooking process has to be supervised. A short term cooking process has to be
supervised continuously.
WARNING: Unattended cooking on a hob with fat or oil can be dangerous and may result in a fire.
An appropriately rated installation male connector that is compatible with the installation female
connector fitted to the final sub-circuit in the fixed wiring that supplies this cooking range (AS/NZS
60335.2.6:2014)
Replacing parts
Before performing any maintenance operation, disconnect the appliance from the
gas supply and electricity network.
To replace parts such as knobs and burners, just remove them from the seats
without disassembling any part of the cooker.
To replace the oven bulb, just unscrew the protection cap that projects out inside the
oven.
Fig.2
WARNING: Before replacing the bulb, disconnect the appliance from the electric power supply.
WARNING: The power cord supplied with the appliance is connected to that appliance with an X
type connec
tion (in compliance with standards EN 60335-1, EN 60335-2-6 and subsequent amendments)
for which it can be installed without the use of special tools, with the same type of cord as the one installed.
If the power cord becomes worn or damaged, replace it based on the information reported in types of
power cords paragraph .
WARNING: If the power cord is replaced, the installer shall ensure that the ground cable is longer than
the phase cables and also shall comply with the warnings regarding the electric connection.
To replace the power cable, lift the terminal board’s cover and replace the cable. To access the terminal
board in cookers with a 3x2.5mm² cable, the back panel on the rear of the appliance must be removed. The
power cord should be replaced only by qualified personnel.
Before disposing of the packaging, please ensure you have removed all the components.
Bekijk gratis de handleiding van Bertazzoni PRO95I2EROT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bertazzoni |
| Model | PRO95I2EROT |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4049 MB |
