Bertazzoni PRO105I2EART handleiding
Handleiding
Je bekijkt pagina 5 van 31
5
The up-stand is packed separate and is taped to the back of the cooker. Other
components can be found inside the ovens. All packaging and covering films must
be removed before the installation can commence.
All electric cookers should be installed by a qualified electrician in accordance with
IEE r
egulations and local electricity provider rules. Building regulations must be
considered when undertaking any installation. Failure to install the appliance
correctly will render the warranty null and void.
Range cookers are heavy and should be handled by two people. Never lift or drag a
range by the oven handles as damage may occur.
Note: Pictures and graphics in this manual cover different models and may vary in
minor details from your cooker.
INSTALLING RANGE COOKER
Rating of Services The rating plate is visible in the storage area of the cooker and a copy is also
attached to last page of the user manual.
Before connecting the cooker, check that the requirements on the rating plate
correspond with those of the electrical system and gas supply (where applicable).
Ensure that the electrical system and isolating switches have a suitable capacity to
carry the maximum power as indicated on the rating plate.This chart can be used as
a guide to the electrical supply ratings.
Cooker model
22
0-240 V
~ 380-415 V2N ~ 380-415 V3N ~
90x60 single oven Induction hob top
3x10 mm
² 4x4 mm² 5x1,5 mm²
90x60 twin oven Induction hob top
3x6 mm
² 4x4 mm² 5x2,5 mm²
100x60 / 110x60 twin oven Induction hob top
3x6 mm
² 4x4 mm² 3x2,5 mm²
100x60 3 oven compartments Induction hob top
3x10 mm
² 4x4 mm² 3x2,5 mm²
Positioning The cooker may be installed in a kitchen or open-plan kitchen diner but not in a
room containing a bath or shower. The cooker should be positioned in an area with
good light and free from draughts.
Any shelf or unit of combustible material should be at least 660mm above the
hotplate. In addition an area of 75mm wide on either side and behind the hotplate
must be clear of any combustible materials to a height of 400mm. Units must not
overhang over the hob.
Kitchen cabinets may be fitted flush to the sides of the cooker, but to allow for
cleaning and servicing
It is recommended that a 2.5mm gap be allowed on each side so that the cooker
may be moved if necessary.
The worktop or kitchen cabinets must not protrude beyond the height of the cooker
hotplate frame.
Ventilation Your appliance is not connected to a combustion products evacuation device. Th
e room in which it is to be installed must have an air supply in accordance with
national standards. The room must have an opening window or equivalent, and
some rooms may require a permanent vent in addition to the opening window.
General guidelines: The cooker must not be installed in a bedsit room of 20m³ or
less. If the cooker is installed in a room with a volume of less than 5m³, then a vent
Bekijk gratis de handleiding van Bertazzoni PRO105I2EART, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bertazzoni |
| Model | PRO105I2EART |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3666 MB |
