Bernette b38 Yaya Han Edition Handleiding (70 Pagina's)

Handleiding

 41

Standard Buttenhole

Stitch pattern: Mode 1 : 0

Mode 2 : 10

Thread tension: 1 - 5

Presser foot: Buttonhole foot with slide

Buttonhole lever sign

• To sew

Press the needle stop up/down button to raise the needle.

Attach the buttonhole foot with slide R snapping the pin

into the notch of the presser foot holder.

Notch

PLEASE NOTE:

If the button is extremely thick, make a test buttonhole on

an extra piece of the fabric.

If it is difﬁcult to ﬁt the button through the test buttonhole,

you can lengthen the buttonhole by pulling the button

holder back a little. The length of the buttonhole will be

increased.

Pull the button holder to the back, and place the button in

it. Push it together tightly against the button.

Pull the buttonhole lever down as far as it will go.

Buttonhole lever

Insert the corner of the fabric under the foot. Press the needle

stop up/down button twice. Remove the fabric to the left to

draw the needle thread through the hole of the foot. Place the

fabric under the foot, and lower the needle at the starting

point of the buttonhole mark . Then lower the Buttonhole

foot with slide.

Buttonhole mark

Starting point

Button holder

Extra gap

PLEASE NOTE:

Make sure that is no gap between slider and stopper.

Otherwise the buttonhole is not sewn properly.

Slider

Stopper

No gap

Sewing gap

Bekijk gratis de handleiding van Bernette b38 Yaya Han Edition, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.