Bernette b05 Crafter handleiding
Handleiding
Je bekijkt pagina 62 van 76
BUTTONHOLES
62
2024-07 EN 5020105.10A.04
6.7 Cut the Buttonhole Open
> Place a pin at each end directly underneath the locking stitch to prevent the stitches being cut open.
> Cut the opening with the seam ripper.
6.8 Sewing On Buttons
The Button Sew-on Program can be used to sew on buttons with two or four holes, press studs or snap
fasteners.
> Fit the zigzag foot or button-sew-on foot.
> Set the stitch pattern selector knob to «B».
> Lower the feed dog.
> Fit the button into the sewing project.
> For a button with four holes, sew the front holes first.
> Check distances between holes with the handwheel. If necessary, alter the stitch width.
> Hold the threads when starting to sew.
> Sew a few stitches using the machine. To ensure stability, sew around 10 stitches.
> To strengthen the shank, cut the threads, leaving about 10cm.
> Bring the upper thread through one of the holes in the button and wind it around the shank.
> Bring the upper thread to the wrong side of the fabric and tie it in a knot.
Bekijk gratis de handleiding van Bernette b05 Crafter, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bernette |
| Model | b05 Crafter |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 14539 MB |
