Bernette b05 Crafter handleiding
Handleiding
Je bekijkt pagina 61 van 76
BUTTONHOLES
61
2024-07 EN 5020105.10A.04
> Set the required stitch length in the buttonhole symbol range on the dial.
> Position the fabric under the presser foot so that marking of the centerline is aligned with the starting
point (1).
1
> Press the buttonhole lever all the way down and press it backwards slightly until it clicks in position.
> Hold the upper thread perpendicular to the buttonhole foot with slide.
> Use the foot control to start sewing.
– The buttonhole is sewn from the front of the presser foot to the back.
1. 2. 3. 4.
> At the end of the buttonhole, where the bead meets the bar, stop the machine.
> Raise the presser foot, remove the fabric and cut the thread.
> Pull the upper thread downwards and tie it in a knot.
> If you must interrupt sewing a buttonhole, pull the buttonhole lever forwards and sew 2–3stitches until
the mechanism has switched over.
> To sew another buttonhole, push the buttonhole lever backwards.
> After sewing the last buttonhole, lift the buttonhole lever as far as it will go.
Bekijk gratis de handleiding van Bernette b05 Crafter, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Bernette |
| Model | b05 Crafter |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 14539 MB |
