Berner Architectural Icon 10 handleiding
Handleiding
Je bekijkt pagina 4 van 16
-4-
II. MOUNTING INSTRUCTIONS (General)
INDOOR MOUNTING ONLY
To achieve optimum protection, the air curtain should be
mounted on the inside of the building, ush to the wall and
as close to the top of the door opening as possible. To ensure
peak performance, keep the air stream free of obstructions.
The air curtain will not perform properly if negative air
pressure exists in the building. Under these conditions,
a means for makeup air to the building must be provided
so that the air pressure on both sides of the opening is in
balance.
Before mounting the air curtain, check the supporting structure
to verify that it has sucient load-carrying capacity to support
the weight of the air curtain(s). The mounting hardware
(supplied by others) should be capable of supporting a
minimum of three (3) times the weight of the air curtain.
See Table 1.
IMPORTANT: A minimum of 4” is required above the top rear
corner of the air curtain for the installation and removal of the
inlet screen, and to ensure proper airow.
A. When determining the mounting location for the air
curtain(s), make sure that nothing interferes with the
curtain of air developed when the discharge vanes
are directed from 0° to 20° toward the door opening. If
the air stream strikes any obstruction (the top edge of the
doorway, a door opening device, etc.), the eectiveness
of the air curtain will be greatly reduced. See Figure 2.
B. For optimum performance, the bottom of the air curtain
(discharge nozzle) should be no more than 1” above
the top of the door opening with the air curtain(s)
mounted ush to the wall. If the air curtain must be
mounted higher, it must be spaced out from the
wall 3/8” for every inch the air curtain is above the door
opening. See Figure 3. For optimum protection, any void
between the air curtain and the wall should be sealed
along the full length of the air curtain.
C. Do not block (obstruct) the air intake screen. Insucient
airow can cause the unit to overheat.
D. The air curtain(s) shall:
1. Have a minimum clearance of at least 4”
from the sides and 4" from the top.
2. Have a minimum clearance of at least 6’
between the bottom of the air curtain and the oor.
3. Be installed Indoors Only.
E. Proceed to either Section III - WALL MOUNTING or
Section IV - SUSPENDED MOUNTING
Figure 2 - General Mounting
Figure 3 - Wall Mounting Location
TABLE 1 - Weight Chart
A. PREPARATION
1. Locate the wall mounting brackets. Two of the wall
mounting brackets are shipped already attached
to the back of the air curtain, and the third
is shipped loose and can be found in the carton that
contained the air curtain. See Figure 4.
III. WALL MOUNTING
20°
AIR
Discharge
Nozzle
A
I
R
A
I
R
INTERIOR
EXTERIOR
6' minimum
AIR
Airstream
4" minimum
side & top
clearance from
combustible
material
AI08 - 9½” MIN.
AI10 - 14” MIN.
AI08 - 4¾”
AI10 - 9
1
/
8
”
AI08 - 4¾”
AI10 - 9
1
/
8
”
MODEL
Net Weight (lbs.)
MODEL
Net Weight (lbs.)
AI10
Amb.
AI10
Elec.
AI10
Steam
AI10
Hot
Water
AI08
Amb.
AI08
Elec.
AI08
Steam
AI08
Hot
Water
AI10-F-1036A 85 88 110 110 AI08-F-1036A
48
53 68 68
AI10-F-1042A 94 97 122 122 AI08-F-1042A
53
58 76 76
AI10-F-1048A 110 113 141 141 AI08-F-1048A
58
63 83 83
AI10-F-1060A 119 122 156 156 AI08-F-1060A
69
74 99 99
AI10-F-2072A 170 176 216 216 AI08-F-1072A
79
89 117 117
AI10-F-2078A 170 194 219 219 AI08-F-2078A
96
106 136 136
AI10-F-2084A 188 194 240 240 AI08-F-2084A
106
116 149 149
AI10-F-2096A 220 226 278 278 AI08-F-2096A
116
126 164 164
AI10-F-2108A 229 235 293 293 AI08-F-2108A
127
137 180 180
AI10-F-2120A 238 244 307 307 AI08-F-2108A
138
148 196 196
AI10-F-3132A 305 314 384 384
AI10-F-3144A 330 339 415 415
Bekijk gratis de handleiding van Berner Architectural Icon 10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Berner |
| Model | Architectural Icon 10 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3492 MB |
