Berner Architectural Contour 8 handleiding

Niet gecategoriseerd

Berner

16 pagina's

PDF beschikbaar

Handleiding

-10-

www.Berner.com/intelliswitch

NOTE – to navigate, use to select setting

use to change setting,

then press to enter the setting.

Stop: Immediately stops the air curtain and changes mode to OFF

"i": info button provides controller status and diagnostic data

Mode/Fan Speed:

Mode: Select your mode of operation (see next page)

Fan Speed: Sets the fan speed

Delay Time: Sets the amount of time the air curtain runs after the door closes

Temp Set: Sets the temperature the air curtain will maintain (heated units only)

Start Time: Programs the time of day the air curtain becomes active

Stop Time: Programs the time of day the air curtain stops running

Set Time/Day: Sets the clock time and day (used by programming)

Locked: Unit will run as programmed but settings cannot be changed

NOTE: Start/Stop time must be the same for the air curtain to operate continuously.

QUICK START INSTRUCTIONS

For your Berner Air Curtain with Intelliswitch™ Gen4

IMPORTANT NOTE!

If your air curtain unit is in “Locked” mode when you receive it:

Press and hold the for 5 seconds to unlock.

www.berner.com Berner International 800.245.4455

111 Progress Ave. / New Castle / PA / 16101 / USA

Bekijk gratis de handleiding van Berner Architectural Contour 8, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.