Berbel Ergoline 2 BKH 110 EG-2 handleiding

Afzuigkap

Berbel

132 pagina's

PDF beschikbaar

Handleiding

128

Maintenance

6006910_0 – 18.11.2023

6.3 Fault rectification

Possible faults are described below:

Description of the fault.

2 Possible cause.

1 Remedy.

Fan and lighting do not work.

2 No power supply.

1 Check that the mains cable is connected on both

sides.

2 The breaker may have been tripped or is defective.

1 Check to see if the breaker has tripped.

1 If you use electric circuit breakers, turn the circuit

breaker on again.

1 For other types of fuse, consult a qualified electrician.

The fan does not work.

2 The device is not switched on.

1 Check all power levels.

, “4.2.1 Normal operation” (page 121).

2 The device is connected to a safety device. The safety

device detects a critical under-pressure.

1 Open a window.

1 Wait until the air pressure returns to normal.

The lighting does not work.

2 The device software requires a restart.

1 Interrupt the power supply for approx. 10 seconds.

2 The lamp has blown.

1 Please consult the customer services.

Smells occur during operation.

2 The filter filling is used up.

1 Change the filter filling.

, “6.2.2 Replacing filter filling” (page 126).

Poor device performance.

2 The recirculated air filter is clogged.

1 Replace the filter filling of the recirculated air filter.

, “6.2.2 Replacing filter filling” (page 126).

Control panel does not react after being touched several times.

2 The control panel is soiled.

1 Clean the control panel.

, “5. Cleaning” (page 124).

2 The device software requires a restart.

1 Interrupt the power supply for approx. 10 seconds.

The smoke can settle on furniture, the fronts of kitchen units and

the ceiling.

2 Smoke development by heating cooking oils and cooking

fats to too high a temperature.

1 Note the smoke point of the cooking oil or fat you

are using. You can obtain this information from the

respective manufacturer.

Moisture in the device.

2 Dripping or splashing water has penetrated the device.

2 Liquid (e.g. from vases, bottles on the device) has

penetrated the device.

1 Immediately shut off the power supply, by removing

the fuse.

1 Make sure that the power supply cannot be

unintentionally reconnected. For example by tasking

a person with ensuring that the fuse/breaker is not

restored/switched on.

1 Ensure that no more liquid can penetrate the device.

1 Allow the device to dry.

1 Have the device checked and repaired by qualified,

specialist personnel prior to using the device again.

If a fault persists:

1 Please consult the customer services.

Bekijk gratis de handleiding van Berbel Ergoline 2 BKH 110 EG-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.