BEKO HTV 8743 XG handleiding
Handleiding
Je bekijkt pagina 20 van 72
20 / EN
Washer-Dryer
Installation
2 Remove the transit bolts by turning them slightly.
3 Attach the plastic covers supplied in the user manual bag into the holes on the rear
panel.
C
INFORMATION
• Keep the transit bolts in a safe place to reuse when the
product needs to be moved again in the future.
• Never move the product without the transit bolts properly
fixed in place!
3.4 Connecting water supply
C
INFORMATION
• The water supply pressure required to run the product is
between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have
10 – 80 liters of water flowing from the fully open tap in
one minute to have your product run smoothly. Attach a
pressure reducing valve if water pressure is higher.
A
CAUTION
• Models with a single water inlet should not be
connected to the hot water tap. In such a case the
laundry will get damaged or the product will switch to
protection mode and will not operate.
• Do not use old or used water inlet hoses on the new
product. It may cause stains on your laundry.
1 2 3
1 Connect the special hose supplied with the product to the water inlet on the
product.
Bekijk gratis de handleiding van BEKO HTV 8743 XG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | BEKO |
| Model | HTV 8743 XG |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 6358 MB |
