BEKO FSGT52110DXON handleiding

104 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 32 van 104
EN / 32
5. Set the flame length to 2 to 3 mm by
means of the screw (1) on the oven tap.
Turning in clockwise direction reduces
the flame, turning counter-clockwise
increases the flame.
If gas flow rate of oven cannot be
set with removing knob, please re-
move the needed oven parts (con-
trol panel, burner plate etc.) and
then set the gas flow rate of oven.
If the temperature of the oven in-
creases excessively, turn off the
oven and call the authorised ser-
vice to have oven thermostat re-
paired.
Adjust the fire to the optimum height as in
the figure by rotating the screw 1 on the
oven gas cock by means of a screwdriver.
Rotating clockwise will increase the fire
height, and rotating counter-clockwise will
decrease the fire height.
If the fire height is too short,
* The internal temperature of the oven may
be too low, therefore the cooking perform-
ance may be affected negatively.
The ideal fire height ensures the best per-
formance.
If the fire height is too high,
* The internal temperature of the oven may
be too high, therefore the cooking perform-
ance may be affected negatively.
After adjusting the flame height,
open and close the oven door for a
couple of times and pay attention
that the flame of the oven does not
go out.
Reinstall the knob after setting the flame
length.
Natural gas to Butane/
propane (LPG)
Tighten the screw by
turning it clockwise until
the end.
Butane/propane (LPG) to
Natural Gas
Loosen the screw
180°
approximately
G20 20
G25 25
G25.3 25
mbar
mbar
mbar
EN
RO

Bekijk gratis de handleiding van BEKO FSGT52110DXON, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkBEKO
ModelFSGT52110DXON
CategorieNiet gecategoriseerd
TaalNederlands
Grootte11697 MB