BEKO FBSM62320SAC handleiding
Handleiding
Je bekijkt pagina 29 van 116

EN / 29
2. While holding the gas connection outlet
of the product fixed with a 22 spanner,
connect the interconnection piece to the
product gas outlet with a 24 spanner
and tighten securely.
3. Insert the new sealing gasket into the
safety gas hose/pipe. Make sure the
gasket is seated correctly.
4. Connect the threaded part of the safety
gas hose/pipe to the interconnector
with the 24 mm spanner and tighten se-
curely, holding the interconnector in
place with the 24 mm spanner.
5. You must check for leakage of the con-
nection part after connection.
Making the gas connection - LPG
• Your product should be connected in a
way that it will be close to the gas con-
nection to prevent gas leakage.
• Before making your gas connection,
provide a plastic gas hose and suitable
mounting clamp. The inner diameter of
the plastic gas hose must be 10 mm and
the length should not be longer than 150
cm. The plastic hose must be leak-proof
and inspectable.
• Gas appliances and systems must be
regularly checked for proper functioning.
Regulator, hose and its clamp must be
checked regularly and replaced within the
periods recommended by its manufac-
turer or when necessary.
• A new sealing gasket must be used while
making the gas connection.
• The gas connection must be made via a
gas hose or a fixed connection.
Connection with clamped (threadless) gas
hose
1. Place the new seal in the connection
piece for liquid gas and make sure the
seal is seated correctly.
2. Secure the gas connection outlet of the
product with a 22 mm spanner, connect
the connecting piece to the gas outlet of
the product with a 24 mm spanner and
tighten securely.
3. Fit the mounting clamp to one end of
the gas hose. Soften the end of the gas
hose to which you have attached the
clamp by placing it in boiling water for
one minute.
4. Insert the softened gas hose all the way
into the connection piece. Tighten the
clamp securely with a screwdriver.
5. You must check for leakage of the con-
nection part after connection.
Leakage check at the connection point
• Make sure that all knobs on the product
are turned off. Make sure that the gas
supply is open. Prepare soapy foam and
apply it onto the connection point of the
hose for gas leakage control.
• Soapy part will froth if there is a gas leak-
age. In this case, inspect the gas connec-
tion once again.
• Instead of soap, you can use commer-
cially available sprays for gas leak check.
EN
RO
Bekijk gratis de handleiding van BEKO FBSM62320SAC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | BEKO |
Model | FBSM62320SAC |
Categorie | Niet gecategoriseerd |
Taal | Nederlands |
Grootte | 12536 MB |