Handleiding
Je bekijkt pagina 14 van 44
14 / EN
Mini Oven / User Manual
3 Installation
3.3 Electrical connection
Connect the product to a grounded outlet/line
protected by a miniature circuit braker of suitable
capacity as stated in the “Technical specifications”
table. Have the grounding installation made by a
qualified electrician while using the product with or
without a transformer. Our company shall not be
liable for any damages that will arise due to using
the product without a grounding installation in ac-
cordance with the local regulations.
A
• The product must be connected
to the mains supply only by an au-
thorised and qualified person. The
product’s warranty period starts
only after correct installation.
Manufacturer shall not be held
responsible for damages arising
from procedures carried out by
unauthorised persons.
• The power cable must not be
clamped, bent or trapped or come
into contact with hot parts of the
product. A damaged power cable
must be replaced by a qualified
electrician. Otherwise, there is risk
of electric shock, short circuit or
fire!
The mains supply data must correspond to the
data specified on the type label of the product. The
rating plate is either seen when the door or the low-
er cover is opened or it is located at the rear wall of
the unit depending on the unit type.
Power cable of your product must comply with the
values in “Technical specifications” table.
C
Power cable plug must be within
easy reach after installation (do not
route it above the hob).
C
While performing the wiring, you
must apply with the national/local
electrical regulations and must use
the appropriate socket outlet/line
and plug for oven. In case of the
product’s power limits are out of cur-
rent carrying capability of plug and
socket outlet/line, the product must
be connected through fixed electri-
cal installation directly without using
plug and socket outlet/line.
A
Before starting any work on the elec-
trical installation, disconnect the
product from the mains supply.
There is the risk of electric shock!
Connect the power cable into the socket.
• Push the product towards the kitchen wall.
• Final check
1. Check electrical functions.
3.4 Future transportation
• Keep the product’s original carton and transport
the product in it. Follow the instructions on the
carton. If you do not have the original carton,
pack the product in bubble wrap or thick card-
board and tape it securely.
• To prevent the wire grill and tray inside the oven
from damaging the oven door, place a strip of
cardboard onto the inside of the oven door that
lines up with the position of the trays. Tape the
oven door to the side walls.
• Do not use the door or handle to lift or move the
product.
C
Do not place any objects onto the
product and move it in upright po-
sition.
Check the general appearance of
your product for any damages that
might have occurred during trans-
portation.
Bekijk gratis de handleiding van BEKO BMO45EAB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | BEKO |
| Model | BMO45EAB |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 4125 MB |
