BEKO BMF40B handleiding
Handleiding
Je bekijkt pagina 14 van 96
14
3 Installation
Refer to the nearest Authorised Service
Agent for installation of the product. Make
sure that the electric and gas installations
are in place before calling the Authorised
Service Agent to have the product ready for
operation. If not, call a qualified electrician
and fitter to have the required arrangements
made. The manufacturer shall not be held
responsible for damages arising from proce-
dures carried out by unauthorized persons
which will also void the warranty.
It is customer's responsibility to
prepare the location the appliance
shall be placed on and to have the
electrical installation prepared.
Do not use the door and/or handle
to transport or move the product.
The door, handle or hinges may be
damaged.
Do not use the product in a closed
cabinet or on the floor level.
Do not install the appliance beside re-
frigerators or coolers. The heat emitted
by the appliance increases the energy
consumption of the cooling units.
Power cable plug must be within
easy reach after installation (do not
route it above the hob).
Do not use extension cables or
multi sockets for power connection.
WARNING:
The product must be installed in
accordance with all local gas and/
or electrical regulations.
WARNING:
Prior to installation, visually check if
the product has any defects on it.
If the product is damaged, do not
install it. Damaged products cause
risks for your safety.
WARNING:
The product can only be connected
to the mains electricity connection
by an authorized and qualified
person, and the warranty of the
product starts only after correct in-
stallation. The manufacturer cannot
be held responsible for any damag-
es that may arise due to operations
made by unauthorized persons.
WARNING:
The electric cable shall not be
crushed, folded, jammed or touch
hot parts of the product.
If the electric cable is damaged,
it shall be replaced by a qualified
electrician.
Right place for installation
This product is intended for use only on a
counter.
Electrical connection
Plug the appliance in a grounded socket
protected by a fuse conforming to the values
specified in the “Technical specifications”
chart. Whether operating with a transformer
or not, have the grounding installation made
by an Authorized Electrician. Our compa-
ny shall not be held responsible for any
damages that may occur if the product is
used without providing proper grounding in
accordance with local regulations.
The mains supply data shall correspond to
the data specified on the type label of the
product. The rating plate is either seen when
the door or the lower cover of the appliance
is opened or it is located at the rear wall of
the appliance depending on the appliance
type. Power cable of your product shall
comply with the values in "Technical specifi-
cations" table.
Installation and connection
Product can only be installed and connected
in accordance with the statutory installation
rules.
The kitchen floor must be able to carry the
weight of the appliance plus the additional
weight of cookware and bakeware and food.
• Any kitchen furniture next to the appliance
shall be heat-resistant (at least 100 °C).
Bekijk gratis de handleiding van BEKO BMF40B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | BEKO |
| Model | BMF40B |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10172 MB |
