Handleiding
Je bekijkt pagina 40 van 340
40 / 340 EN
Split type air conditioner / User Manual
If refrigerant piping is already embedded in the
wall, do the following:
1. Hook the top of the indoor unit on the upper
hook of the mounting plate.
2. Use a bracket or wedge to prop up the unit,
giving you enough room to connect the
refrigerant piping, signal cable, and drain hose.
Wedge
3. Connect drain hose and refrigerant piping (refer
to Refrigerant piping connection section of
this manual for instructions).
4. Keep pipe connection point exposed to perform
the leak test (refer to Electrical checks and
leak checks section of this manual).
5. After the leak test, wrap the connection point
with insulation tape.
6. Remove the bracket or wedge that is propping
up the unit.
7. Using even pressure, push down on the bottom
half of the unit. Keep pushing down until the
unit snaps onto the hooks along the bottom of
the mounting plate.
Unit is adjustable
Keep in mind that the hooks on the mounting
plate are smaller than the holes on the back of
the unit. If you find that you don’t have ample
room to connect embedded pipes to the indoor
unit, the unit can be adjusted left or right by about
30-50mm (1.18-1.96in), depending on the model.
Move to left or right
30-50mm
(1.18-1.96in)
30-50mm
(1.18-1.96in)
8 Indoor unit installation
Bekijk gratis de handleiding van BEKO BEVPG 240/ BEVPG 241, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | BEKO |
| Model | BEVPG 240/ BEVPG 241 |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 35842 MB |
