BEKO BDFN26460PA handleiding
Handleiding
Je bekijkt pagina 46 van 52
EN / 46
cycle, as the salt particles remaining un-
der the lid will dissolve in the pre-wash
step, and thus the lid may loosen.
• Water hardness setting is low or salt level
is inadequate. >>> Check the water hard-
ness setting by measuring the hardness
of the mains water accurately.
• The dishes are not placed properly. >>>
When placing glasses and other glass kit-
chenware in the basket, do not lean them
against other dishes, but on the edges of
the basket, on the racks or on the glass
supporting wire. When two glasses or
other dishes being washed hit each other
due to the impact of water during wash-
ing operation, this may cause scratching/
breaks on the surfaces.
• A blurred stain that looks like a milk soil
remains on glasses, which cannot be re-
moved when wiped by hand. When ex-
posed to light, a bluish /rainbow coloured
appearance is observed.
• Excessive amount of rinse aid is used.
>>> Lower the setting of rinse aid. While
adding the rinse aid, always clean the
rinse aid overflown to the surroundings.
• Corrosion has occurred on the glass due
to soft water. >>> Check the water hard-
ness setting by measuring the hardness
of the mains water accurately. Do not use
salt if your mains water is soft (<5 dH).
Use cycles with a higher temperature set-
ting (e.g. 60-65 degrees) for washing.
You may also use commercially available
glass-protecting detergents.
Foam occurs in the dishwasher.
• Dishes are washed by hand with dish
washing detergent and then put into the
dishwasher without rinsing before they
are placed in the dishwasher. >>> No
foam control characteristics are available
in dish washing detergents intended for
hand washing. You do not need to hand
wash the dishes with detergent before
placing them in the dishwasher. Simply
rinse off the coarse soil on the surface of
the dish with water or scrape it off with a
paper napkin or a fork.
• Rinse aid was spilt into the dishwasher
while adding rinse aid. >>> Take care not
to spill rinse aid into the dishwasher
while adding rinse aid. Clean spilt rinse
aid with a paper napkin/towel.
• The rinse aid reservoir lid has been left
open. >>> Make sure to close the rinse
aid reservoir lid after adding rinse aid.
Kitchenware break.
• Dishes are placed irregularly. >>> Place
the dishes as specified in the user
manual.
• Baskets are overloaded. >>> Do not load
baskets above their capacity.
• Water remains in the dishwasher after
the end of the cycle.
• Filters are clogged. >>> Check whether
the filter system is cleaned. Clean the fil-
ter system regularly as shown in the
"Cleaning and maintenance" section.
• The drain hose is clogged / blocked. >>>
Inspect the drain hose. Remove the hose
if required to remove the blockage and
then install it again as described in the in-
stallation instructions.
10 BEKO UK AND ROI STANDARD MANUFACTURER GUARANTEE
TERMS AND CONDITIONS
Your new Beko product is guaranteed
against faulty materials, defective compon-
ents or manufacturing defects.
The standard guarantee starts from the
date of original purchase of the product
and lasts for a period of twelve (12)
months unless Beko plc (the “Manufac-
turer”) agrees to extend the guarantee
for the product in writing. If you have
purchased an American style Fridge
freezer, the standard guarantee starts
from the date of original purchase of the
product, and lasts for a period of twenty
Bekijk gratis de handleiding van BEKO BDFN26460PA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | BEKO |
| Model | BDFN26460PA |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 6479 MB |
